Operation - Cub Cadet LS 27 CC Operator's Manual

Operation

Starting the Engine
WARNING!
Read, understand and follow all
instructions and warnings on the machine and in
this manual before operating.
WARNING!
Wear leather work gloves, safety shoes,
and safety glasses when operating a log splitter.
Ensure safe footing.
Before Each Use
1. With the spark plug wire disconnected, remove the dipstick
and check hydraulic fluid level. Refill if necessary. Approved
fluids include Dexron® III / Mercon® automatic transmission
fluid or a 10 Weight AW hydraulic oil.
2. Check engine oil level. Refill if necessary.
3. Fill up gasoline if necessary.
4. Lubricate the beam area where splitting wedge will slide
with engine oil. Do not use grease to lubricate. Make sure
to lubricate both the front and the back of the beam face.
5. Attach spark plug wire to the spark plug.
Starting Engine
1. Attach the spark plug wire to the spark plug. Make certain
the metal cap on the end of the spark plug wire is fastened
securely over the metal tip of the spark plug.
2. Turn the fuel valve or engine switch (if equipped) to the ON
position.
3. Move the choke lever (if equipped) to CHOKE position.
4. If the engine is equipped with a primer, follow the
instructions in the engine manual to prime it.
5. Turn the throttle control (if equipped) to the FAST position.
6. Grasp starter handle and pull rope out slowly until engine
reaches start of compression cycle (rope will pull slightly
harder at this point).
7. Pull the rope with a rapid, full arm stroke. Keep firm grip on
starter handle. Let rope rewind slowly. Repeat until engine
cranks.
8. After the engine starts, move the choke lever (if equipped)
to the OFF position. Place the throttle lever to the speed
desired.
9. In cold weather, run wedge up or down beam 6 to 8 times
to circulate the hydraulic fluid.
WARNING!
When starting a warm engine, the
muffler and surrounding areas are hot and can
cause a burn. Do not touch.
Stopping the Engine
1. Move throttle control (if equipped) to STOP or OFF
position.
2. Turn off the engine switch, if so equipped.
Using the Log Splitter
1. Place the log splitter on dry level ground and shut off the
engine.
2. Place the beam in either the horizontal or vertical position
and lock in place with the appropriate locking rod.
NOTE: Take extra care when raising and lowering the beam
as it is fairly heavy. Be sure to keep hands away from any
possible pinch points.
3. To place the beam in the Vertical Position proceed as
follows:
a. Pull the horizontal beam lock out to release the
beam and pivot the beam to the vertical position.
b. To lock the beam in the vertical position, pull out on the
vertical beam lock and rotate it to secure the beam.
See Fig. 5-1.
1
Vertical Beam Lock
Figure 5-1
5
2
11