Miele G 886 Operating Instructions Manual page 47

Problem
A whistling noise is
heard during the pro-
gram
Knocking noise in the
water pipes
Three horizontal bars
show in the time display
at the end of the pro-
gram:
– – –
Possible cause
The circulation pump seal
sometimes makes a whis-
tling noise. This may be
caused by the detergent.
This may be caused by
the installation or the or
the piping.
There may be a technical
fault.
Problem solving guide
Remedy
This is not a problem. Try
other detergents. Consult
the Miele Technical Ser-
vice Department if the
noise is persistent.
This has no affect on
dishwasher. If in doubt
contact a plumber.
– Turn the program se-
lector to the "Stop" po-
sition.
– Turn off the dishwasher
using the "On/Off" but-
ton.
After a few seconds:
– Turn the dishwasher on
using the "On/Off" but-
ton.
– Turn the Program se-
lector to the desired
program.
– Press the "Start" but-
ton.
If the three horizontal bars
appear again at the end
of the program, there is a
technical fault.
– Call the Miele Techni-
cal Service Depart-
ment.
Despite the problem the
dishwasher can be used
in all programs but, the
water will not heat. The
"Energy Saver" program
only works if the dish-
washer is connected to a
hot water supply.
47