Dodge Avenger 2011 Owner's Manual page 129

Watch for the HomeLink indicator to change flash
rates. When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you train.
NOTE:
• Some gate operators and garage door openers may
require you to replace Step 3 with procedures noted in
the "Gate Operator/Canadian Programming" section.
• After training a HomeLink channel, if the garage
door does not operate with HomeLink and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to Step 5 "Programming A Rolling Code
System."
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 127
• Press and hold the just-trained HomeLink button and
observe the indicator light.
If the indicator light stays on constantly, programming
is complete and the garage door (or device) should
activate when the HomeLink button is pressed.
If the indicator light blinks rapidly for two seconds and
then turns to a constant light, proceed to "Programming
A Rolling Code System."
Programming A Rolling Code
At the garage door opener motor (in the garage), locate
the "Learn" or "Training" button.
3