About This Guide; Safety Notes - Chauvet Q-Spot 560 LED Quick Reference Manual

Chauvet q-spot 560 led quick reference guide
Table of Contents

Advertisement

Q-Spot™ 560 LED QRG
About this
Guide
Disclaimer
Safety
Notes
What Is
Included
The Q-Spot™ 560 LED Quick Reference Guide (QRG) only contains the
product's connection and mounting information, as well as the menu options
and the DMX values.
This Quick Reference Guide DOES NOT replace the product's User
Manual, which you can download from the CHAUVET® Web site
(www.chauvetpro.com).
You must read ALL the disclaimers and Safety Notes in this document,
as well as those in the product's User Manual before installing,
operating, or maintaining this product.
DO NOT open this product unless instructed. It contains no user
serviceable parts.
DO NOT aim this product toward any surface closer than 3.3 feet (1 m).
You may damage or overheat the illuminated surface.
DO NOT aim this product toward the Sun. The lenses could concentrate
the solar energy and cause internal overheating.
DO NOT look at the light source when this product is on.
DO NOT touch the product when it is operating because it may be very
hot.
DO NOT cover the ventilation slots when the product is operating to
avoid internal overheating.
DO NOT install or operate this product where there is less than 50 cm to
the nearest surface to allow adequate ventilation around it.
DO NOT leave any flammable material within 50 cm from this product
while operating or connected to the power outlet to minimize the risk of
fire.
DO NOT carry this product from the head. Use the handles instead.
DO NOT lift the unit by the housing. Use the handles instead.
DO NOT mount this product overhead without using a safety cable.
DO NOT operate this product outdoors or in any location where dust,
excessive heat, water, or humidity may affect it.
DO NOT operate this product if you see damage on the housing, lenses,
or cables. In any of these cases, have the damaged parts replaced by an
authorized technician immediately.
DO NOT connect this product to a dimmer or rheostat.
ONLY connect this product to a grounded and protected circuit.
One Q-Spot™ 560 LED
One IEC Power Cord with Edison
Plug (US Market)
Two Mounting Brackets
Page 2 of 16
One Safety Cable
One Warranty Card
One Quick Reference Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Green thinking q-spot 560 led

Table of Contents