About Track Numbers - Sharp MD-MT285E Operation Manual

Advanced Recording (continued)
MD-MT285E

! About track numbers

1. Track numbers are created automatically during re-
cording via the analogue connection when a silence of
1 second or more is detected (Auto marker function).
A series of tracks can be recorded as one by disabling
the auto marker function (see page 29).
About
1 second
Silence
First track
2. When recording from a CD or a MiniDisc using the dig-
ital connection, track numbers will be created at the
same points as on the CD or MiniDisc (Synchro mark-
er function).
First track Second track Third track
Playback
side Track A
First track Second track
Recording
side Track A
" Track numbers may not be created in proper places,
depending on the source to be recorded from, such as
signals with noise.
" The track numbers on the playback side may not
match the track numbers recorded on the MiniDisc.
30
MD-MT285E TINSE0539AWZZ
" When recording, if a programmed playback is per-
formed by the source or playback is performed by
selecting tracks manually, the MiniDisc track numbers
may not be the same as on the source.
" Track numbers may not be created properly, depend-
ing on the connected stereo system.
! About sampling rate converter
This portable MD incorporates a sampling rate converter
Second track
so that it can record from digital radios or DAT tape
recorders.
! Note for digital recording
You cannot copy a MiniDisc that you recorded from digital
inputs to another MiniDisc or DAT. It is prevented by the
SCMS (Serial Copy Management System). Recording
from analogue inputs is not affected.
Track B Track C
Digital signals
Third track
Track B Track C
CD player,
MiniDisc
player,
etc.
Digitally recorded Cannot record
MiniDisc
Digital Digital
connection connection
03/7/15 MD_MT285E_4.fm