Optical Drive - HP 6720s Maintenance And Service Manual

Remove the memory module (2) by pulling the module away from the slot at an angle.
4.
NOTE:
memory module slot.
Reverse this procedure to install a memory module.

Optical drive

NOTE: All optical drive spare part kits include an optical drive bezel.
Description
DVD±RW and CD-RW Super Multi Double-Layer Combo Drive with LightScribe
DVD±RW and CD-RW Super Multi Double-Layer Combo Drive
DVD/CD-RW Combo Drive
Before removing the optical drive, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the optical drive:
Position the computer with the right side toward you.
1.
Remove the Torx T8M2.5×7.0 screw (1) that secures the optical drive to the computer.
2.
Insert a flat-bladed screwdriver or similar tool into the optical drive tab access (2) and press the tab
3.
to the left to release the optical drive from the computer.
44 Chapter 4 Removal and replacement procedures
Memory modules are designed with a notch (3) to prevent incorrect installation into the
Battery on page 37).
Spare part number
456799-001
456798-001
456797-001