Table of Contents
Advertisement
Unpacking
Before starting the machine up, the packing
must be removed as follows.
You are advised to keep all the packaging for re-
use in case the machine has to be transported
again.
Using a spanner unscrew and remove the rear right
bolt. Lay the machine gently on its back, making
sure that the hoses are not squashed.
Remove the polystyrene blocks from underneath
the machine.
Release the two polythene bags by removing the
adhesive strip.
Carefully remove the right polythene bag (1) by
pulling it towards the centre of the machine. Repeat
the operation for the left polythene bag (2).
Set the machine upright and remove the two
remaining bolts from the back.
Pull out the three plastic spacers from the holes
into which the bolts were fitted.
Plug the open holes with the plugs which you can
find at the back of the appliance.
6
INSTALLATION
P0255
P0647
P0256
2
1
P0233
P0020
Advertisement
Table of Contents
