Table of Contents
Advertisement
Cleaning the filter
The water drain filter
A clean filter is important for the correct functioning
of the machine, and should therefore be cleaned
after every washing programme.
Open the filter door and place a container
underneath to catch any spillage. If the filter is
blocked and the machine is unable to drain you will
need to drain the water manually from the machine
at this stage. To do this, unhook the drain hose
from the standpipe or sink and hold the end of the
hose over a bowl on the floor. The water should
drain by gravity into the bowl. When the bowl is full,
hook the hose back up and empty the bowl. Repeat
the procedure until water stops flowing out.
Unscrew and remove the filter.
Clean carefully under a fast running tap.
Warning
When the appliance is in use and depending on the
programme selected there can be hot water in the
filter. Never remove the filter during a wash cycle,
always wait until the appliance has finished the
cycle, and is empty. When replacing the filter,
ensure it is securely retight-ened so as to stop
leaks and young children being able to remove it.
The water inlet filters
If your water is very hard or contains traces of lime
deposit, the water inlet filters may become clogged.
It is therefore a good idea to clean them from time
to time.
Turn off the water taps. Unscrew the water inlet
hoses. Remove and clean the filters using a hard
bristle brush. Replace the filters and tighten up the
inlet hoses.
P0011
P0133
P0040
P0041
P0132
19
Advertisement
Table of Contents
