New Zealand Modem Statements - HP 2533T Getting Started

462939-001.book Page 45 Thursday, March 20, 2008 9:03 AM
The Japanese certification mark for the V.92 56K Data/Fax Modem is below:
The Japanese certification mark for the V.92 56K Data/Fax Modem is below:

New Zealand modem statements

The grant of a Telepermit for any item of terminal equipment indicates only that
Telecom has accepted that the item complies with minimum conditions for
connection to its network. It indicates no endorsement of the product by Telecom,
nor does it provide any sort of warranty. Above all, it provides no assurance that
any item will work correctly in all respects with another item of Telepermitted
equipment of a different make or model, nor does it imply that any product is
compatible with all of Telecom's network services.
This equipment is not capable, under all operating conditions, of correct operation
at the higher speeds for which it is designed. Telecom will accept no responsibility
should difficulties arise in such circumstances.
If this device is equipped with pulse dialing, note that there is no guarantee that
Telecom lines will always continue to support pulse dialing.
Use of pulse dialing, when this equipment is connected to the same line as other
equipment, may give rise to bell tinkle or noise and may also cause a false answer
condition. Should such problems occur, the user should not contact the Telecom
Faults Service.
Some parameters required for compliance with Telecom's Telepermit requirements
are dependent on the equipment (PC) associated with this device. The associated
equipment shall be set to operate within the following limits for compliance with
Telecom's Specifications:
1. There shall be no more than 10 call attempts to the same number within any
30-minute period for any single manual call initiation.
2. The equipment shall go on-hook for a period of not less than 30 seconds
between the end of one attempt and the beginning of the next attempt.
Getting Started
Product information
45