Table of Contents
Advertisement
Configuring the ISDN gateway
Step one: Log in to the ISDN gateway
All administration of the ISDN gateway is performed via the web interface.
To log in to the ISDN gateway:
1
Log in to the Supervisor's web interface.
2
Go to
Hardware > Blades
3
Click
Click here to log in
name
admin
Codian recommends that you change the admin account to use a
i
password as soon as possible. To do that, go to
link, and provide the required user information.
Step two: Set up the ISDN interfaces
1
In the web interface, go to
2
Select the
ISDN interface type
used in the UK and mainland Europe, T1 (USA and Canada) in North America,
and T1(Japan) in Japan.
3
Complete the other settings as required by your network, referring to the online
help for further information.
4
Click
Apply changes
5
Restart the ISDN gateway (this is only necessary if you changed the ISDN
configuration). To do this:
i
Go to
Settings > Shutdown
ii
Confirm that you want to shut down the ISDN gateway.
iii Click
Restart ISDN GW
6
When the ISDN gateway has restarted, log in to the web interface again, and go
to
Settings > ISDN ports
7
Complete the settings for ISDN Port 1 as required by your network, referring to
the online help for further information. Note that all ISDN ports on the ISDN
gateway are enabled by default.
8
Click
Apply changes
9
If required, configure another ISDN port by selecting the port number from the
numbered links at the top right of the ISDN port configuration page.
8
and click the IP address of the ISDN gateway.
, and then click
with no password.
Settings > ISDN
to save any changes you have made to the configuration.
.
.
to save your configuration changes to the ISDN port.
Change log in
.
to match that of your installation; E1 is typically
, and click
Shut down ISDN GW
and enter the user
, click the
Users
admin
.
Advertisement
Table of Contents
