Diagnostics Menu - HP EliteBook 6930p Maintenance And Service Manual

Select
Change Password
HP SpareKey Enrollment
DriveLock Passwords
Automatic DriveLock
Disk Sanitizer
System IDs
Always Prompt for HP SpareKey
Enrollment

Diagnostics menu

Select
System Diagnostics menu
106 Chapter 5 Computer Setup
To do this
Enter, change, or delete a BIOS administrator password.
Enroll or reset HP SpareKey, which is a set of security questions and answers used if you
forget your password.
●
Enable/disable DriveLock on any computer hard drive (enabled by default).
● Change a DriveLock user password or master password.
NOTE: DriveLock settings are accessible only when you enter Computer Setup by turning
on (not restarting) the computer.
Enable/disable Automatic DriveLock support.
Run Disk Sanitizer to destroy all existing data on the primary hard drive.
CAUTION: If you run Disk Sanitizer, the data on the primary hard drive is destroyed
permanently.
Enter a user-defined computer asset tracking number and ownership tag.
Enable/disable a prompt for HP SpareKey enrollment.
To do this
●
F1 System Information—Displays the following information:
◦ Identification information for the computer and the batteries in the system.
◦
Specification information for the processor, cache and memory size, system
ROM, video revision, and keyboard controller version.
●
F2 Start-up Test—Verifies the system components needed for starting the computer.
●
F3 Run-In Test—Runs a comprehensive check on system memory.
●
F4 Hard Disk Test—Runs a comprehensive self-test on any hard drive in the system.