Download Print this page

GE TFX27F Use And Care Manual page 20

Refreshment center, electronic monitor and diagnostic system
Hide thumbs Also See for TFX27F:

Advertisement

Rapid Electrical Diagnosis
Your refrigerator is wired for accurate
~
m
Questions?
electrical diagnosis in your home—takes
only minutes for a service technician to
-.~.
Use This Problem Solver
check its entire electrical system. No need for
the technician to unplug, move or unload
—.
the refrigerator to make the diagnosis.
PROBLEM
NO PANEL T13UCH
PAD RESPONSE
REFRIGERAlOR
DOES N(YI'
OPERATE
MOIUR OPERATES
FOR LONG PERIODS
M~R
STARTS&
STOPS FREQUENTLY
VIBRATION OR
RATTLING
H(YI'AIR FROM
B(YI''I0MOF
REFRIGERATOR
DOOR N~
CLOSING
PROPERLY
POSSIBLE CAUSE AND REMEDY
!
If interior light is not on, refrigerator may not be plugged in at wall outlet.
I
If plug is secure and the refrigerator still fails to operate, plug a lamp
or a small
appliance into the same outlet to determine
if there is a tripped circuit breaker or
burned out i%se.
May be in defrost cycle when motor does not operate for about 30 minutes.
Temperature control in OFF position.
!
I
If interior light is not on, refrigerator may not be plugged in at wall outlet.
~
If plug is secure and the refrigerator still fails to operate, plug a lamp or a small
I
[
appliance into the same outlet to determine
if there is a tripped circuit breaker or
I
burned out fuse.
i
Modem refrigerators with more storage space and a larger freezer compartment
require more operating time.
I
~
Normal when refrigerator is first delivered
to your home—usually requires 24 hours
to completely cool down.
Large amounts of food placed in refrigerator to be cooled or frozen.
Hot weather—frequent door openings.
Door left open.
c Temperature controls are set too cold. Refer to instructions for use of
TEMPERATURE CONTROLS on page 5.
Grille and condenser need cleaning. Refer to page 18.
Check ENERGY-SAVINGTIPS on page 2.
Temperature control starts and stops motor to maintain even temperatures.
If refrigerator vibrates, more than likely it is not resting solidly on the
floor and front
roller screws or front leveling legs need adjusting or floor is weak or uneven. Refer to
ROLLERS on page 4.
If dishes vibrate on shelves, try moving them. Slight vibration is normal.
Defrost water pan rattling, needs to be positioned properly.
Normal air flow cooling motor. In the refrigeration process. it is normal that heat be
expelled in the area under the refrigerator. Some floor coverings will discolor at these
normal and safe operating temperatures.
Your floor covering supplier should be
consulted
if you object to this discoloration.
Door gasket on hinge side sticking or folding over. To correct. put a small amount of
petroleum jelly on face of gasket.
. .
11–
II
L---
1

Advertisement

loading