Table of Contents
Advertisement
WLBARGMO Manual
<Windows XP/ 2000>
(1) Click [Start] => [Programs] => [Command prompt].
(2) Input [ipconfig] => [Enter].
(3) Confirm IP address (which sould be 192.168.1.x). If the IP is incorrect, please
enter 1-byte character as [ipconfig /renew] => Press [Enter].
<Windows Me/ 98/ 95>
(1) Click [Start] => Click [Run].
(2) Input [winipcfg] in the column => press [Enter].
(3) Select your network adapter to display IP address. The IP should be
192.168.1. x ,if none, please click [Release] => Click [Renew].
Q8. How to reboot the product?
A: Reboot to get new setting values applied. The steps are as follows: open the
management program-> Click on [Management]-> Click on [Proceed] in the
[Reboot] column.
*Note: The definitions of [Reboot], [Firmware update], and [Reset to default settings]
are different. Please make sure of your intention before proceeding.
Q9: How to reset to default settings?
A: If you forget the password, get failed in setting or product hang up; you can
reset the product's settings to default values.
(1) Use a spindle item (e.g. a clip) to press [Reset button] in the front side of the
product until [Status] light goes out.
(2) When the [Status] light starts to flash, the system has reset to its default
values.
52 52 52
Advertisement
Table of Contents
