Cub Cadet Z-Force S 60 Operator's Manual page 10

Installing the LPG Tank
1. Open the straps and carefully place the LPG tank into the
straps with the cylinder valve guard towards the left. Be
sure that the alignment pin fits into the slot on the bottom
of the cylinder valve guard. See Fig. 3-3.
Cylinder Valve Guard
Slot
Alignment Pin
2. When the tank is in place, secure it by locking down the
straps (A). See Fig. 3-4.
B
C
3. Install the regulator hose on the LPG tank fuel valve (B) and
secure it by twisting it counter-clockwise(C). See Fig. 3-4.
NOTE: The hose has left-handed threads to prevent
improper usage.
10 s 2— a
ectiOn sseMbly
Figure 3-3
A
Figure 3-4
& s -u
et p
Steering Wheel Column
The steering wheel column is tilted all the way back for shipping
purposes. To tilt the column forward, press the steering tilt pedal.
Release the steering tilt pedal when the column is in the desired
position.
Steering Wheel
1. Remove the hardware for attaching the steering wheel
from beneath the steering wheel cap. Carefully pry off the
steering wheel cover to remove the hardware.
2. With the wheels of the tractor pointing straight forward,
place the steering wheel over the steering shaft.
3. Place the flat washer and belleville washer over the
steering wheel and secure with the hex screw. See Fig. 3-5.
Hex Screw
Belleville Washer
Steering Wheel
A
4. Place the steering wheel cover over the center of the
steering wheel and push downward until it "clicks" into
place.
Steering Wheel Cover
Flat Washer
Steering Wheel
Column
Figure 3-5