Power Cord; Connecting The Monitor - HP L156v User Manual

Setting Up the Monitor

Power Cord

Be sure the power cord is the correct type required in your region.
This LCD monitor has an internal universal power supply that
allows operation in either 100/120V AC or 220/240V AC voltage
area (No user adjustment is required.)
✎
A certified power supply cord has to be used with this equipment.
The relevant national installation and/or equipment regulations
shall be considered. A certified power supply cord not lighter
than ordinary polyvinyl chloride flexible cord according to IEC
60227 (designation H05VV-F 3G 0.75mm2 or H05VVH2-F2 3G
0.75mm2) shall be used. Alternative: a flexible cord of synthetic
rubber according to IEC 60245 (designation H05RR-F 3G
0.75mm2) shall be used.

Connecting the Monitor

1. Connecting the signal cable: Connect one end of the signal
cable into the LCD monitor's socket, the other end into the
computer's VGA port, and tighten the two screws on the cable
connector.
2. Connecting the power cord: Connect one end of the
AC-power cord into the LCD monitor's AC input socket, the
other end into the wall outlet.
Ä
CAUTION: If the AC outlet is not grounded (with three holes), install
the proper grounding adapter (not supplied).
3. Connecting the audio line: Connect one end of an audio
cable into the computer's multimedia (or sound) card's audio
output, and the other end into the monitor's audio input.
3–2 User Guide