Lto Ms1 Speaker Modeller - Alto PASSIVE Owner's Manual

3.
-. THE FRONT PANEL
(2)
(1)
1. Gain Control
This control adjusts the input gain by a range of -20 dB to +20 dB.
2. Clip LED
This LED lights up when the input signal is too strong. It warns that the
output signal may cause distortion. Please attenuate the level of the input
signal.
3. Presets Selector
Via this knob, you can select the right effect you wish to perform. There
are total 16 options for you, JAZZ CLUB+SUB, VIRTUAL SUB, STAGE
MONITOR, JAZZ CLUB, CONCERT HALL+SUB, DISCO, VOCAL, ROCK &
ROLL, FLAT, DRUM KICK, ANTIRUMBLE, CONCERT HALL, ARENA+SUB,
LOUDNESS, ROCK & ROLL+SUB and ACOUSTIC.
4. Power LED
This LED lights up when the unit is powered on.
-. THE REAR PANEL
5. AC Inlet
This jack is used to connect the AC power supply with the supplied 15V AC
adapter.
6. Output Connector
This is a balanced 1/4" TRS jack, which is used to connect devices such as
the effects returns on a mixing console or power amplifier inputs.
7. Input Connector
This is a balanced 1/4" TRS jack, which connects to sources such as the
effect sends of mixing console.

LTO MS1 SPEAKER MODELLER

SPEAKER MODELLER
R
LTO
M S 1
CLIP
ACOUSTIC
ROCK & ROLL+SUB
0dB
LOUDNESS
ARENA+SUB
CONCERT HALL
ANTIRUMBLE
MIN MAX
DRUM KICK
GAIN
15VAC~
RIGHT
POWER
(5)
JAZZ CLUB+SUB
VIRTUAL SUB
STAGE MONITOR
JAZZ CLUB
CONCERT HALL+SUB
DISCO
VOCAL
ROCK & ROLL
FLAT
OUTPUT
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
LEFT RIGHT
(6)
(4)
POWER
(3)
INPUT
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
LEFT(MONO)
(7)
5