Spirit Esprit EL255 Owner's Manual page 9

STEP 1: CONSOLE MAST ASSEMBLY
• Locate the Console Mast (10) and Console Mast Cover (41) and slide the Cover onto the Mast as
far as it will go. Make sure the Console Mast Cover is facing the correct way.
• At the top opening of the Main Frame (1) there is a Computer Cable (32) attached to a guiding
wire. Unravel the wire and feed the Computer Cable into the bottom of the Console Mast tube
and out of the top opening.
• Install the Console Mast (10) into the receiving bracket on the top of the Main Frame. Pull slightly
on the computer cable at the top of the mast while installing, this will ensure the cable does not
get pinched and shorted during mast assembly.
• Install two 3/8" Split
Hex Head Bolt (119) and
Console Mast; just hand tighten for now. Install two 3/8" Flat Washers (94) and two 3/8" Split
Washers (120) onto two 3/8" x 3" Hex Head Bolts (119). Install them through the left side of the
receiving bracket into the Console Mast. Now tighten all 3 bolts as tight as possible and snap the
console mast cover into place.
• There are three connectors at the top opening of the Console Mast; two Hand pulse wires (37)
and one Computer Cable (32). Connect these to the mating connectors on the back of the
Console Assembly (31). Store the excess wiring back into the Console Mast (10) as you carefully
install the Console Assembly (31) onto the mounting plate of Console Mast. Secure the console
with four M5 Phillips Head Screws (78).
Washers (120) and
one of the 3/8" x 3/4" Hex Head Bolt (121)
•
two 3/8" Curved Washers
8
(114) onto one of the 3/8" x 3"
install through the front of the
EL255 Elliptical