Linear PERS-2400 Installation Instructions page 2

INSTALLING TRANSMITTERS (FROM FRONT PANEL)
ADDS ONE TRANSMITTER AT A TIME
1 PRESS CLEAR BUTTON
FOR 5 SECONDS
5 BEEPS SOUND
(TX ADD MODE)
2
ACTIVATE TRANSMITTER
1 BEEP SOUNDS
(TX ADDED)
CONSOLE REVERTS
TO OPERATE MODE
NOTE: FOR ALL TWO-BUTTON TX'S EXCEPT DXS-63
3 REPEAT STEPS 1 & 2
FOR ADITIONAL
TRANSMITTERS
(UP TO 16 TOTAL)
NOTE: IF THE CONSOLE'S MEMORY
IS FULL, ONE LONG BEEP SOUNDS WHEN
TRYING TO ADD A TRANSMITTER
NOTE: FOR DXS-31 STATIONARY TRANSMITTERS
NOTE: PRESS CLEAR BEFORE
INSTALL WITH
TRANSMITTING TO RETURN
JUMPER SET
TO OPERATE MODE WITHOUT ENTERING FOR DELAY
A TRANSMITTER (2 BEEPS SOUND WITH
ACTIVITY TIMER ENABLED, 3 BEEPS
SOUND WITH ACTIVITY TIMER DISABLED)
THE CONSOLE WILL RESUME OPERATE
MODE AUTOMATICALLY AFTER
DXS-32: CUT JUMPER (INSTANT TX) FOR USE AS AN
ACTIVITY TX. SEE DXS-32 INSTALLATION INSTRUCTIONS
30 SECONDS
ERASING TRANSMITTERS
NOTE: ALL TRANSMITTERS WILL BE ERASED!
1 PRESS AND HOLD TEST
BUTTON FOR 5 SECONDS
6 BEEPS SOUND
(ALL TRANSMITTERS
WERE ERASED)
2
PRESS CLEAR TO RETURN TO OPERATE
MODE (2 BEEPS SOUND WITH ACTIVITY
TIMER ENABLED, 3 BEEPS SOUND WITH
ACTIVITY TIMER DISABLED) THE CONSOLE
WILL RESUME OPERATE MODE AUTOMATICALLY
AFTER 3 MINUTES
SYSTEM OPERATION
CONSOLE
STANDING BY
POWER LIGHT IS ON
OTHER LIGHTS ARE OFF
- IN CASE OF EMERGENCY -
PRESS AND
- OR -
MOMENTIARLY ACTIVATE
HOLD
EMERGENCY
EMERGENCY
TRANSMITTER
BUTTON
PRESS TRANSMITTER
BUTTON FOR AT LEAST
2 SECONDS
CONSOLE
IN ALARM
SENDING LIGHT
FLASHES DURING
COMMUNICATION
AUDIO BOARD OPERATION
PROGRAM THE CONSOLE FOR
1
NOTE: TO USE THE AUDIO FEATURES
THE DESIRED AUDIO MODE
THE MODEL VB-4 AUDIO MODULE
• LISTEN-ONLY
MUST BE INSTALLED IN THE CONSOLE
• 2-WAY MANUAL
• 2-WAY FULL DUPLEX
AFTER THE CENTRAL STATION
2
OPERATOR ACKNOWLEDGES
THE COMMUNICATOR'S REPORT,
THE CONSOLE WILL STOP ITS
SIREN AND SWITCH TO THE
AUDIO MODE FOR 90 SECONDS
CENTRAL STATION OPERATOR:
3
USE THESE KEYS ON A TELEPHONE SET
CONNECTED TO THE COMMUNICATOR LINE
TO CONTROL THE AUDIO MODULE
ALL
AUDIO PRESS "9" TO DISCONNECT THE CALL
MODES
PRESS "3" TO LISTEN
2-WAY MANUAL
AUDIO MODE
PRESS "1" TO TALK
THE "1" AND "3" KEYS ARE NOT USED IN LISTEN-ONLY AUDIO MODE
THE "1" AND "3" KEYS CAN BE USED IN FULL DUPLEX MODE,
ALTHOUGH THE MODULE WILL SWITCH TO 2-WAY MANUAL
MODE. PRESS "8" TO RETURN TO DUPLEX MODE.
PRESSING ANY KEY OTHER THAN "9" WILL EXTEND THE AUDIO TIME 90 MORE SECONDS
INSTALLING TRANSMITTERS (FROM INSIDE CONSOLE)
PRESS TEST BUTTON
1
4 BEEPS SOUND
(TEST MODE)
2 PRESS TEST BUTTON
AGAIN 5 BEEPS SOUND
(TX ADD MODE)
ACTIVATE TRANSMITTER
3
INSTALL INSTALL 1 BEEP SOUNDS
WITH WITH
(TX ADDED)
LEFT RIGHT
BUTTON BUTTON
NOTE: IF THE CONSOLE'S MEMORY
IS FULL, ONE LONG BEEP SOUNDS
ACTIVATE ACTIVATE
WHEN TRYING TO ADD A TRANSMITTER
WITH WITH
EITHER BOTH
BUTTON BUTTONS
REPEAT STEPS 2 & 3 FOR
4
ADDITIONAL TRANSMITTERS
INSTALL WITH (UP TO 16 TOTAL)
JUMPER SET
FOR INSTANT
PRESS CLEAR TO RETURN
5
TO OPERATE MODE (2 BEEPS SOUND
WITH ACTIVITY TIMER ENABLED, 3 BEEPS
ACTIVATES
ACTIVATES
SOUND WITH ACTIVITY TIMER DISABLED)
AS EMERGENCY
AS ACTIVITY
OTHERWISE, THE CONSOLE WILL RESUME OPERATE
MODE AUTOMATICALLY AFTER 3 MINUTES
CONNECTING TO RA-2400 FOR LOCAL CABLE PROGRAMMING
PERFORM THE STEPS DETAILED IN THE
1
RA-2400/PERS-2400 REFERENCE GUIDE (P/N 217163)
TO SET UP THE RA-2400 PROGRAM
TO LOCALLY PROGRAM
2
THE CONSOLE, CONNECT
THE MODEM'S LINE JACK
TO THE CONSOLE'S LINE
JACK
PRESS TEST BUTTON
3
MOMENTARILY, 4 BEEPS
SOUND (TEST MODE)
NOTE: CONSOLE WILL EXIT TEST MODE
AUTOMATICALLY AFTER 3 MINUTES
OR BY PRESSING THE CLEAR BUTTON
WHEN RA-2400 CONNECTION TIMER
4
STARTS COUNTING DOWN, PRESS
THE EMERGENCY BUTTON
4 BEEPS SOUND (RA-2400 ANSWER)
PERFORM PROGRAMMING IN
5
THE RA-2400 SOFTWARE, THEN
DISCONNECT FROM THE CONSOLE
TRANSMITTER LOW BATTERY TROUBLE
WHEN A TRANSMITTER SENDS A LOW BATTERY SIGNAL THE
CONSOLE'S TROUBLE INDICATOR WILL BLINK SLOWLY.
TRANSMITTER SUPERVISORY TROUBLE
IF A TRANSMITTER PROGRAMMED AS SUPERVISED FAILS
TO REPORT STATUS IN A 24 HOUR PERIOD, THE CONSOLE'S
TROUBLE INDICATOR WILL LIGHT.
CONSOLE BACKUP BATTERY TROUBLE
THE CONSOLE WILL TEST ITS BACKUP BATTERY EVERY 8 HOURS.
IF THE BATTERY TESTS LOW, THE POWER INDICATOR WILL BLINK
SLOWLY WHILE THE CONSOLE CHARGES THE BATTERY.
SIREN SOUNDS
UNTIL CLEAR BUTTON
IS PRESSED,
THE CONSOLE WILL REPORT
CENTRAL STATION
TROUBLE AND/OR 30-DAY STATUS
REPORT IS COMPLETE,
TO THE CENTRAL STATION IF
OR SIREN TIME EXPIRES
ENABLED IN THE COMMUNICATOR
PROGRAMMING
PRESS CLEAR TO
STOP SIREN
(ADDS CANCEL TO
ALARM REPORT IN
PROGRESS)
NOTE: THE TROUBLE CONDITION WILL LIKELY OCCUR AGAIN UNTIL THE PROBLEM IS FIXED
CODING FORMATS
POWER REQUIREMENTS
RF CHARACTERISTICS
COMMUNICATOR
SECONDARY TELEPHONE NUMBER
SUPERVISORY TELEPHONE NUMBER
CONSOLE
ADDS MULTIPLE TRANSMITTERS
LINE-TO-LINE
SUPERVISORY CONDITIONS
WHEN TROUBLE EXISTS,
THE CONSOLE WILL BEEP EVERY
HOUR UNTIL CLEARED:
2-BEEPS = CONSOLE LOW BATTERY
3-BEEPS = TRANSMITTER SUPERVISORY
4-BEEPS = TRANSMITTER LOW BATTERY
NOTE: THE CONSOLE WILL ANNOUNCE
THE SUPERVISORY CONDITIONS WITH
THE OPTIONAL MODEL VB-4 VOICE
BOARD INSTALLED. THE VOICE CAN
BE DISABLED THROUGH
PROGRAMMING
CLEARING TROUBLE INDICATIONS
PRESS THE CLEAR BUTTON TO STOP TROUBLE
INDICATORS AND SOUNDERS
SPECIFICATIONS
DX CODE 24-BIT A1D PPM 1,048,567 CODES
DXS CODE 24-BIT A1D PPM 1,048,567 CODES
PRIMARY SUPPLY 16 VAC 1.25 AMP PLUG-IN TRANSFORMER
BACKUP SUPPLY 12 VOLT 1.2 AMP/HOUR BATTERY
NORMAL OPERATING CURRENT 80 mA
ALARM OPERATING CURRENT 120 mA
BACKUP OPERATION DURATION 12 HOURS MINUMUM
BATTERY LIFE EXPECTED 3 YEARS
RECEIVER TYPE DUAL-DIVERSITY SUPERHETERODYNE
RF SENSITIVITY -100 dBm TYPICAL
RADIO FREQUENCY 315 Mhz
MAXIMUM RANGE 400 FEET LINE-OF-SIGHT, OPEN RANGE
UL LISTED FOR 150'
COMMUNICATOR FORMATS 4 BY 2 (GENERAL OR POINT-TO-POINT), ADEMCO
CONTACT ID
UL TESTED WITH SURGARD SGMLRG-DG CENTRAL
STATION RECEIVER
DIALING TONE OR PULSE
DIALING DELAY 0 OR 15 SECONDS
REMOTE ACCESS PASSWORD 6 DIGITS
ACCOUNT NUMBER LENGTH 4 DIGITS
PRIMARY TELEPHONE NUMBER 20 DIGITS
20 DIGITS
20 DIGITS
CONSOLE STATUS REPORT OPTIONAL 1, 7 OR 30 DAY REPORT
OPERATING TEMPERATURE 32°-100° F (0-50° C)
EMERGENCY ALARM DURATION 1-30 MINUTES
ACTIVITY TIMER PERIOD 8, 12, OR 24 HOURS
AUDIO LISTEN-ONLY, 2-WAY MANUAL, 2-WAY DUPLEX
RELAY OUTPUT N.O./N.C. (FORM C) @ 24 VOLT AC/DC 1 AMP
MAXIMUM, NEC CLASS II CIRCUITRY
TESTING TRANSMITTERS
1 PRESS TEST BUTTON
4 BEEPS SOUND
(TEST MODE)
2
ACTIVATE EACH OF
THE CONSOLE'S
TRANSMITTERS,
ONE AT A TIME
COUNT THE NUMBER
3
OF BEEPS THAT THE
CONSOLE SOUNDS
WHEN THE TRANSMITTER
IS ACTIVATED
1-BEEP = TX OK
2-BEEPS = TX HAD ALARM
3-BEEPS = TX MISSED STATUS
4-BEEPS = TX HAS LOW BATTERY
NOTE: WITH THE MODEL VB-4 VOICE BOARD
INSTALLED, THE CONSOLE WILL ANNOUNCE
THE TRANSMITTER STATUS
4
PRESS CLEAR TO RETURN TO
OPERATE MODE (2 BEEPS SOUND
WITH ACTIVITY TIMER ENABLED,
3 BEEPS SOUNDS WITH ACTIVITY TIMER
DISABLED) OTHERWISE, THE CONSOLE WILL RESUME
OPERATE MODE AUTOMATICALLY AFTER 3 MINUTES
TELEPHONE CONNECTIONS
TELEPHONE
JACK
ROUTE CABLES UNDER
STRAIN-RELIEF TABS
LOCAL
TELEPHONE
CONNECT LOCAL
TELEPHONE TO
THIS JACK
CONNECT TELEPHONE
LINE TO THIS JACK
ACTIVITY TIMER
ENABLING THE ACTIVITY TIMER
1
PRESS THE HOME BUTTON FOR 5 SECONDS
TO TURN THE ACTIVITY TIMER ON
2 ACTIVITY TIMER RUNNING 3 TIME RUNNING OUT
THE HOME INDICATOR WILL BLINK & A SHORT
THE HOME INDICATOR WILL LIGHT, SHOWING
BEEP SOUNDS EVERY 10 SECONDS WHEN
THAT THE ACTIVITY TIMER IS ENABLED
LESS THAN 15 MINUTES OF TIME REMAIN
4 RESETING ACTIVITY TIMER
THE SUBSCRIBER NEEDS TO PRESS
THE HOME BUTTON OR TRIGGER AN
ACTIVITY TRANSMITTER BEFORE THE
TIMER EXPIRES TO PREVENT
AN INACTIVITY REPORT
PRESSING THE HOME BUTTON
RESTARTS THE TIMER
IMPORTANT !!!
Linear radio controls provide a reliable communications link and fill an important need in portable
wireless signaling. However, there are some limitations which must be observed.
• For U.S. installations only: The radios are required to comply with FCC Rules and Regulations
as Part 15 devices. As such, they have limited transmitter power and therefore limited range.
•
A receiver cannot respond to more than one transmitted signal at a time and may be blocked by
radio signals that occur on or near their operating frequencies, regardless of code settings.
•
Changes or modifications to the device may void FCC compliance.
•
Infrequently used radio links should be tested regularly to protect against undetected interference
or fault.
•
A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale
distributor or dealer, and these facts should be communicated to the ultimate users.
PERS-2400
CONSOLE WITH
REAR COVER
INSTALLED
NOTE: THE ACTIVITY TIMER CAN
BE ENABLED FOR 8, 12, OR 24 HOURS,
OR DISABLED BY PROGRAMMING
NOTE: TO TURN THE ACTIVITY
TIMER OFF, PRESS THE HOME BUTTON
FOR FIVE SECONDS