Before Starting Engine; Add Oil/Gasoline - Husqvarna HU725AWD Operator's Manual

Walk-behind mowers
Hide thumbs Also See for HU725AWD:
Table of Contents

Advertisement

Available languages

Available languages

BAG
HANDLE

BEFORE STARTING ENGINE

ADD OIL (See Fig. 11)
Your lawnmower is shipped without oil in the engine. For
type and grade of oil to use, see "EN GINE" in the Mainte-
nance section of this manual.
CAUTION: DO NOT overfi ll engine with
oil, or it will smoke heavily from the
muffl er on startup.
1. Be sure lawnmower is level.
2. Remove oil dipstick from oil fi ll spout.
3. You receive a container of oil with the unit. Slowly
pour the entire container down the oil fi ll spout into the
engine.
NOTE: Initial oil fi ll requires only 18 oz. due to residual oil
in engine from the manufacturers 100% quality testing.
When changing oil you may need 20 oz.
4. Insert and tighten dipstick.
IMPORTANT:
Check oil level before each use. Add oil if needed. Fill
to full line on dipstick.
Change the oil after every 25 hours of operation or
each season. You may need to change the oil more
often under dusty, dirty conditions. See "TO CHANGE
ENGINE OIL" in the Maintenance section of this manual.
OPERATION
CATCHER
HANDLE
FIG. 10
ADD GASOLINE (See Fig. 11)
Fill fuel tank to bottom of tank fi ller neck. Do not over-
GRASS
fi ll. Use fresh, clean, regular unleaded gasoline with
a minimum of 87 octane. Do not mix oil with gasoline.
FRAME
Purchase fuel in quan ti ties that can be used within 30
days to assure fuel freshness.
Acidic gas can damage the fuel system of an
engine while in storage. To avoid engine prob-
lems, the fuel system should be emptied before
stor age of 30 days or longer. Empty the gas tank,
start the engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel next
season. See Storage In struc tions for additional
information. Never use engine or carburetor
cleaner products in the fuel tank or permanent
damage may occur.
GASOLINE
FILLER CAP
TO STOP ENGINE
To stop engine, release operator presence con trol bar.
TO START ENGINE
NOTE: Due to protective coatings on the engine, a small
amount of smoke may be present during the initial use of
the product and should be considered normal.
NOTE: Your engine is equipped with an automatic choke
system. No priming or choking is required before starting.
To start engine, hold operator presence control bar
down to the han dle and pull starter handle quickly. Do
not allow starter rope to snap back.
9
CAUTION: Alcohol blended fuels
(called gasohol or using ethanol or
methanol) can attract moisture which
leads to separation and for ma tion of
acids during storage.
FIG. 11
OIL FILL CAP/
DIPSTICK

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

961430103

Table of Contents