Siemens Mouse User Manual page 25

User Guide
June 2000 Edition
After deinstalling the ID
Mouse, an error message
appears during rebooting,
stating that certain
services cannot be
started.
After the computer has
not been used for a while
all memory resources are
exhausted. Possibly all
you can do is boot your
PC.
The USB drivers will not
run on the computer.
There is no USB
registration under
settings/control-
panel/devices
After the installation
another PC card will not
work e.g. Network card
During installation
protection violation or the
Error 1385 is displayed.
While rebooting the
computer, resp. after the
ID Mouse installation, it
takes a long time until
the user can register.
After installation an error
is displayed that the
installation failed.
After installing the
software the registration
with the ID Mouse no
longer works (the
standard registration
always appears)
Parts in the masks are
not clearly visible or
bitmaps are moved.
With driver problems how
can you manually
deinstall the software in
order to run, for example,
a Windows System
again.
During deinstallation the USB Drivers are not completely
removed. The error will have no effect on the functionality
of the computer. The deinstallation routines in version 3.0
will cleanly remove all components.
Remedy: Delete the registry settings manually.
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Enu
m\Root\LEGACY_USBBULK
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Enu
m\Root\LEGACY_USBDRV
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Enu
m\Root\LEGACY_USBMOUSE
This problem only exists in version 1.0 and can only be
resolved by installing a newer version of the software.
It was established that the USB drivers will not run on dual
processor. This is due to a Microsoft fault in NT4.
Enter the setup programme by starting the computer
(usually with F2) and adjust under Menu Advanced by PCI
Components, that the USB Interrupt of this card is
blocked or allocate the USB with another Interrupt.
In this case, the problem can only be removed with
installation of the ID Mouse Software Version 3.0.
After rebooting the computer all network drives and NT
settings are loaded. In this period nothing from the ID
Mouse can be displayed.
You should check if the user has sufficient rights on the
computer to carry out the installation (Write protection of
the system directories, in the registry etc)
In this case, the deinstallation programm of the other
software also removed parts of the ID Mouse. Remedy:
Deinstall the ID Mouse and reinstall again.
The problem appears when setting up large typefaces.
Resetting the typeface to normal will resolve the problem.
Delete the following files from the system directory:
usbdrv.sys, usbmouse.sys, usbbulk.sys
Siemens ID Mouse V3.1
Siemens ID Mouse FAQs and troubleshooting
WinNT4 V1.0,
V1.1,
V2.0
WinNT4 V1.0
WinNT4 All
All All
WinNT4 V1.0,
V1.1,
V2.0
WinNT4 All
WinNT4, All
Win2k
WinNT4, All
Win2k
All All
All All
Page 25