Chapter 6: Using The Wireless Ethernet; Web-Based Utility; Overview; Starting The Web-Based Utility - Linksys Instant Wireless Series User Manual

11. The configuration using the Setup Wizard is complete. To configure any
other Bridges on your network, run this Setup Wizard again. To exit the
Setup Wizard, click the Exit button.
Important: To activate the new settings, reset the Bridge. Turn off
the Bridge, and wait a few seconds. Then power on the Bridge.
The Wireless Ethernet Bridge is now successfully set up for your network.
After you have reset the Bridge, unplug the Ethernet network cable from the
PC, and plug it into the RJ-45 port of the Ethernet-ready network device you
wish to add to the wireless network.
For more advanced configuration, keep the Bridge plugged into the PC,
and proceed to "Chapter 6: Using the Wireless Ethernet Bridge Web-
16
Instant Wireless
Figure 5-11
Based Utility."
Series Wireless Ethernet Bridge
TM
Chapter 6: Using the Wireless
Ethernet Bridge Web-Based
Utility

Overview

The Bridge is designed to function properly after configuration using the Setup
Wizard. However, if you would like to change these settings or make more
advanced configuration changes, use your web browser and the Wireless
Ethernet Bridge Web-Based Utility. This chapter explains how to use the
Utility.

Starting the Web-Based Utility

1. Open your web browser, and enter the IP address of the Wireless Ethernet
Bridge (see Figure 5-3). Press the Enter key, and the screen shown in
Figure 6-1 will appear. In lowercase letters, enter admin in the Password
field (the default password is admin). Click the OK button. You can set a
new password on the Admin screen later.
Figure 6-1
17