Cisco 1712 Hardware Installation Manual page 3

Chapter 2 Installation
The Cisco 1711 Security Access router is a fixed configuration router that
includes a 1-port analog modem card (WIC-1-AM) that is installed in the WAN
interface card (WIC) slot 1.
The Cisco 1712 Security Access router is a fixed configuration router that
includes a 1-port Integrated Services Digital Network Basic Rate Interface
(ISDN-BRI) S/T interface card (WIC-1B-S/T) that is installed in WIC slot 1.
Both the Cisco 1711 and Cisco 1712 Security Access routers also include an
integrated 4-port 10/100-Mbps Ethernet switch in WIC slot 0, which is supported
only on secure Cisco IOS images.
For additional information and technical specifications about the 1-port analog
Note
modem interface, WIC-1-AM card, refer to the V.90 Modem WAN Interface Cards
on the Cisco 1700 Series Routers.
For additional information and technical specifications about the 1-port ISDN
BRI (S/T interface), WIC-1B-S/T card, refer to the Cisco 3600/2600 Series ISDN
BRI Connectivity Options.
The WIC-1-AM, WIC-1B-S/T and the Ethernet switch WIC are not field
Note
replaceable.
To connect the Cisco 1711 Security Access router or the Cisco 1712 Security
Access router to the local network, follow these steps:
Connect one end of the cable to the yellow Ethernet port (labeled
Step 1
10/100 ETHERNET), as shown in
OL-4050-02
Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide
Connecting the Router to Your Local Network
Figure 2-1 on page 2-4.
2-3