Wall Mounting - Cisco 1712 Hardware Installation Manual

Optional Installation Steps
Step 2
Step 3
Wall-Mounting
Step 1
Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide
2-14
Connect the DB-9 end of the cable to the DB-9 end of the DB-9-to-DB-25 adapter.
Connect the DB-25 end of the adapter to the modem.
The Cisco 1711 and Cisco 1712 Security Access routers can be wall-mounted
using two number six, 3/4-inch screws and the molded mounting brackets on the
bottom of the hub, as shown in
recommend using pan-head or round-head screws.
Figure 2-7 Wall-Mount Brackets—Bottom of Router
Mounting
bracket
3.75"
Bottom
(9.52 cm)
of router
Mounting
bracket
To mount the router on a wall or other surface:
Install the two screws 3.75 inches (9.52 centimeters) horizontally apart on a wall
or other vertical surface.
The screws should protrude 0.25 inch (0.64 centimeter) from the surface of the
wall.
Figure 2-7. You must provide the screws. We
Front panel of router
Chapter 2 Installation
Mounting
bracket
Mounting
bracket
OL-4050-02