Cisco Catalyst 4500 series Overview page 9

Chapter 1 Module Overview and Specifications
•
•
Table 1-1
Table 1-1
LED
STATUS
UTILIZATION Green 1–100%
LINK
ACTIVE
78-13267-06
The Reset button (recessed), which allows you to reset the system
The CompactFlash port and eject button (WS-X4013+, WS-X4013+ TS,
WS-X4013+10GE, WS-4014, WS-X4515, WS-X4516, and
WS-X4516-10GE supervisor engines only) (refer to
Flash on the Catalyst 4000 Family Supervisor Engine III and
describes the supervisor engine LEDs.
Supervisor Engine LEDs
Color/State
Green
Red
Orange
Off
Green
Orange
Flashing orange The power-on self-test indicates a faulty
Off
Green
Off
Description
Indicates the results of a series of self-tests.
All diagnostic tests passed.
A test failed.
System boot or diagnostic test is in
progress.
Module is disabled.
If the switch is operational, this display
indicates the current traffic load over the
backplane (as an approximate percentage).
Indicates the status of the 10/100BASE-T
Ethernet management port or uplink ports.
The link is operational.
The link is disabled by user.
port.
No signal is detected or there is a link
configuration failure.
Indicates whether the uplink port is active
or not.
The port is active.
The port is not active.
Catalyst 4500 Series Module Installation Guide
Supervisor Engines
Using the Compact
IV.)
1-9