Cisco Catalyst 4500 series Overview page 3

Chapter 1 Module Overview and Specifications
The supervisor engines have the following features:
•
•
•
•
•
•
•
To install a supervisor engine, follow the procedure in the
Modules" section on page
The supervisor engines used in Catalyst 4000 and Catalyst 4500 switches are
shown in
78-13267-06
Data path and control for all network interfaces
Management functions:
Interface monitoring
–
Environmental status
–
SNMP and console/Telnet interface
–
Hot-swapping
Note Packets are not forwarded while the module is removed. A system
reboot occurs when a supervisor engine is reinserted.
The Supervisor Engine II-Plus TS provides 12 nonblocking
10/100/1000BASE-T (RJ-45) ports and 8 1000BASE-X (SFP) ports.
The Supervisor Engine II-Plus 10GE and Supervisor Engine V-10GE provide
2 nonblocking 10GBASE uplink ports.
The Supervisor Engine II-Plus 10GE and Supervisor Engine V-10GE provide
4 1000BASE-X (SFP) ports.
The Supervisor Engine IV and V support the Catalyst 4500 series NetFlow
Services Card (WS-F4531). NetFlow is integral to the Supervisor Engine
V-10 GE.
Figure 1-1 to Figure
3-2.
1-8.
Catalyst 4500 Series Module Installation Guide
Supervisor Engines
"Installing the
1-3