Table of Contents
Advertisement
2. Control command configuration
The command consists of the address code, function code, data code, ACK/NAK, and end code. The length of the
command varies among the functions.
Address code
ASCII
'30h' '30h'
Character
[Address code]
[Function code]
[Data code]
[ACK/NAK]
[End code]
3. Control sequence
Computer
Projector
1
2
3
4
NAK return
In the following cases, the projector returns the command with ":N" added.
(1) Though the command sent from the computer is received by the projector successfully, it cannot be
executed because the projector is in the operation prohibition state.
(2) The data length of the sent command is incorrect or the command is invalid.
When a command is sent out during the following operations, it may not be executed.
(1) During signal switching
(2) In the process of the auto position
(3) After the power is turned on.
The projector receives no commands for about 20 seconds (or for 2 minutes at the longest if the lamp does
not light up promptly as the life is expiring). In this case, the projector returns the received command with
NAK added.
The return command is sent out within 1 second at the latest.
When sending commands successively, wait to receive the return command of the current command before
sending a next command.
The projector may not receive a command when the splash screen is being displayed immediately after turning
on the power. Use command "00r10" to cancel the splash screen.
While using the LAN terminals, the LAN functions take precedence.
For the LAN terminals, the same commands as those for connecting with the TCP/IP (port number 63007) are
available. Note, however, that the response becomes slightly slower than when using the RS-232C terminals.
For the use of LAN terminals, see page 10.
Function code
Function
00
Function
Fixed to 00. ('30h' '30h' in the ASCII code)
Code unique to each control operation.
Data (value) unique to each control operation (Not always indicated.)
Code indicating the NAK return as described below
Fixed to :N ('3Ah' '3Eh' in the ASCII code. Not added to ACK.)
Fixed to
. ('0Dh' in the ASCII code)
Sequence
Send the command from the personal
1
computer to the projector.
The projector will send a return
command after it receives an end code.
2
The personal computer checks the
command and confirms if the sent
3
command has been received or not.
Use the check command to see if the
projector has executed the command.
4
Data code
ACK/NAK
Data
'3Ah' '4Eh'
Data
:N
If the projector does not receive commands
normally, that is, if the projector is not connected
physically or unable to receive commands, it does
not send out a return command.
The projector sends out a return command within
one second at the latest.
When the received command cannot be executed,
NAK is returned (as described below).
This projector sends various codes other than the
return code. When having a control sequence by
RS-232C, reject other codes from the personal
computer.
2
End code
'0Dh'
Note
Advertisement
Table of Contents
