RuggedCom RS900W Installation Manual page 2

Copyright
This document contains proprietary information, which is protected by copyright. No part of this document may be
photocopied, reproduced or translated to another language without the prior written consent of RuggedCom Inc.
Disclaimer
RuggedCom has checked the contents of this manual against the hardware and software described. However,
deviations from the description cannot be completely ruled out. RuggedCom shall not be liable for any errors or
omissions contained herein or for consequential damages in connection with the furnishing, performance, or use of this
material. The information given in this document is reviewed regularly and any corrections will be included in
subsequent editions. RuggedCom reserves the right to revise this document or withdraw it at any time without prior
notice.
FCC Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his expense.
Caution
This product contains a laser system and is classified as a "CLASS 1 LASER PRODUCT". Use of controls or
adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
Important
This product contains no user serviceable parts. Attempted service by unauthorized personnel shall render all
warranties null and void.
This unit should be installed in a restricted access location where access can only be gained by service personnel or
users who have been instructed about the reasons for the restrictions applied to the location and about any
precautions that shall be taken; and access is through the use of a tool or lock and key, or other means of security, and
is controlled by the authority responsible for the location.
Trademarks
Ethernet is a trademark of Xerox Corporation
RuggedSwitch, RuggedRated, ROS and eRSTP are trademarks of RuggedCom® Inc.
Warranty
RuggedCom warrants to Purchaser that Products are free from defects in material and workmanship for five (5) years
after shipment. For warranty details, visit http://www.ruggedcom.com or contact your customer service representative.
Contacting RuggedCom
Corporate Headquarters
30 Whitmore Road,
Woodbridge, Ontario, L4L 7Z4
Canada
Toll Free: (888) 264-0006
Tel: (905) 856-5288
Fax: (905) 856-1995
North America: (954) 922-7975 | North America (Toll Free): (866) 922-7975 | International: +1 (905) 856-5288
US Corporate Headquarters
1930 Harrison St. Suite-307
Hollywood, Florida, 33020
USA
Toll Free: (866) 922-7975
Tel: (954) 922-7975
Fax: (954) 922-7984
Technical Support:
Email: support@ruggedcom.com
European Headquarters
Unit 41, Aztec Centre
Aztec West, Almondsbury, Bristol
BS32 4TD, United Kingdom
Tel: +44 1454 203 404
Fax: +44 1454 203 403