Brother HL-1110 Product Safety Manual page 15

15 Some parameters required for compliance with Telecom's Telepermit requirements are
dependent on the equipment (PC) associated with this device. The associated equipment shall
be set to operate within the following limits for compliance with Telecom's Specifications:
 There shall be no more than 10 call attempts to the same number within any 30 minute
period for any single manual call initiation.
 The equipment shall go on-hook for a period of not less than 30 seconds between the end
of one attempt and the beginning of the next call attempt.
 Automatic calls to different numbers are spaced such that there is not less than 5 seconds
between the end of one call attempt and the beginning of another.
 Equipment shall be set to ensure that calls are answered within 3 and 30 seconds of the
receipt of ringing.
16 In the event of any problem with this device, it is to be disconnected, and a CPE item connected
to one of its terminal ports may be connected directly in its place. The user should then arrange
for the product to be repaired. Should the matter be reported to Telecom as a wiring fault and
the fault is proven to be due to this product, a call out charge will be incurred by the customer.
17 The caller ID telephone numbers that are displayed and stored in this equipment include the
caller's area code but not the toll access "0" prefix. When calling back it is necessary to add a
"0" to the telephone number, or if the telephone number is a local number, omit the area code
digit. If the toll services of a service provider other than Telecom are being used then a toll
charge may be incurred if the "0" prefix toll access code and area code are used.
IMPORTANT NOTICE (MFC only)
Under power failure conditions, this telephone may not operate. Please ensure that a separate
telephone, not dependent on local power, is available for emergency use in emergencies.
1
15