Hotpoint FEW10 Instructions For Installation And Use Manual page 4

1
IMPORTANT:
Situated, one either
side of the rear panel,
BOTH transit bolts
(complete with
spacers) MUST be
removed before use...
Failure to do so may
cause damage to
your machine!
3
DRAINAGE SYSTEM... we recommend one of the following:
NOTE: ALTHOUGH YOU MAY NEED TO
MOVE THE HOOKED END SUPPORT
ALONG THE GREY DRAINAGE HOSE,
DO NOT REMOVE IT.
WHICHEVER DRAINAGE METHOD
YOU USE, MAKE SURE THAT THE
HOOKED END SUPPORT IS FIXED
LEVEL TO, OR ABOVE THE 'PLUMBING
INDICATOR LINE'*
(*see Getting to Know your Appliance)
WO FRONT FEET ARE NOT
M AND LEVEL.
ck the machine stands level... from
ine into its final location
trap or kink the hoses.
h front feet anti-clockwise by
eet cannot be turned any more.
ch foot will stop them coming
t to ensure that there is adequate
REMOVE TWO TRANSIT FIXINGS...
Unscrew the
STOP when 3
bolt using a
threads can be
13mm spanner.
seen.
STANDPIPE METHOD
Hooked End Support
Insert drainage hose
approximately 100mm
into the standpipe.
.............................
Standpipe height:
minimum 500mm
from the floor.
5
CONNECT TO THE POWER SUPPLY...
PLUG YOUR MACHINE INTO AN ELECTRICAL SOCKET WHICH IS
EASILY ACCESSIBLE. SWITCH ON.
Installation
Follow these instructions to remove the TWO transit fixings.
For safety,insert
one of the
plastic covers
Hold, slide
(supplied with
sideways and
your machine)
pull to remove.
over the hole.
UNDER SINK METHOD
OR
cut off the blocked
end of the under sink
drainage unit.
NOTE: Hotpoint recommend
extension leads are not used.
Move your machine into position,
take care not to trap or kink the
hoses.
It is important the transit
bolt and spacer come out
intact (see pic).
! Repeat steps to remove
the second transit bolt.
800mm
from floor
Fix the hooked Attach the GREY
end support at drainage hose to the
a minimum under sink drainage
800mm from unit securely, using a
the floor. hose clip.
6
READY...
TO CHECK ALL PARTS OF
CLEAN THE INSIDE OF YO
RUN PROGRAMME 'C' (
✗
THIS WILL TAKE APPRO
WITHO
W