Cisco 3800 Series Quick Start Manual page 24

For information about installing a second power supply in the Cisco 3845 router, see the Cisco 3800 series hardware
Note
installation documentation at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/3800/hw/index.htm
Before connecting the RPS to the router, make sure that either the RPS is in standby mode or the RPS AC power is
Caution
disconnected. Connecting the RPS to AC power automatically places the RPS in active mode.
Figure 20 RPS Connector on the Cisco 3825 Router
R
RPS connector
Figure 21 Plugging the RPS Connector into the Cisco 3825 Router
R
WAN, LAN, and Voice Connections
The connections and cables listed in Table 3 are described in detail in the Cisco 3800 series hardware installation documents at
the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/3800/hw/index.htm
Note An Ethernet cable is typically provided with the router. Additional cables and transceivers can be ordered from Cisco. For
ordering information, contact customer service. For cable pinouts, see the
Cisco Modular Access Router Cable Specifications
Warning Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Statement 1036
24
CO MP AC
1
T FL AS H
0
SYS
AUX
ACT
RPS
IP PW R
AIM 0
AIM 1
PVD M0
PVD M1
PVD M2
PVD M3
CO MP AC
1
T FLA SH
0
SYS
ACT SYS
PW R
AUX
RPS
PW R
AIM 0
AIM 1
PVD M0
PVD M1
PVD M2
PVD M3
document.