HP Q1910 User Manual page 16

9. Slide the column mounting bracket away from the bottom of the monitor.
Figure 3-7
10. Remove the Compaq logo from the back of monitor to expose the top two threaded holes (A) and
(B) for the wall mount bracket. Place the tip of a small, flat blade screwdriver under the logo to pry
it up.
NOTE:
Figure 3-8
Use the four holes (A), (B), (C), and (D) to attach the swing arm or other mounting fixture to the
back of the monitor with screws (not supplied).
11. Follow the instructions included with the mounting fixture to ensure that the monitor is safely
attached.
The four threaded holes that are on the back of the panel are compliant with the VESA standard
for mounting flat-panel monitors.
12. Attach a swing arm or other mounting fixture.
10 Chapter 3 Setting Up the Monitor
Sliding the column mounting bracket from the monitor
The logo is held in place by rubber cement.
Removing the logo from the back of the monitor
A
C
B
D
ENWW