Table of Contents
Advertisement
2
Hardware Installation
Floppy Disk Drive Connector
1
The system board is equipped with a 26-pin FPC type floppy disk
drive connector. Only connect a 1.44MB slim-type floppy disk drive.
Floppy drives other than the one mentioned above are optional.
Refer to the next page for the pin function of this connector.
Connecting the Floppy Disk Drive Cable
Install one end of the floppy disk drive cable into the floppy disk
connector (J7) on the system board and the other end of the
connector to the floppy drive. Pin 1 of the cable must align with pin
1 of J7.
BIOS Setting
Enable or disable this function in the Integrated Peripherals submenu
("Super IO Device" field) of the BIOS. Refer to chapter 3 for more
information.
47
Advertisement
Table of Contents
