Table of Contents
Advertisement
Connecting the Speaker
1. Strip 1 to 2 inches (2.5 to 5 cm) off the end of the
cable jacket. Then strip ½ inch (1.3 cm) of insulation
off each wire.
2. Twist the wire strands together so there are no
strands separated from the bundle.
3. Connect the wires to the speaker terminals, being
sure to observe proper polarity. For standard speaker
cable with red and black wires, connect the red wire
to the red positive (+) terminal and the black wire to
the black negative (–) terminal.
Note: Some speaker cables may have other ways of
designating polarity. For example, cable with a clear
jacket usually has a copper-colored wire for positive and
a silver-colored wire for negative. In a cable with white
and black wires, the white is positive and the black is
negative. Cable with both wires the same color may
have grooves, ribs, or stripes on the positive wire.
Final Assembly
1. Rotate the speaker to the desired angle.
Note: If you are installing the speaker outdoors in the
horizontal position, rotate it so the front points down
toward the listening area. Avoid pointing the speaker
upward to keep rain from entering the ports.
2. Tighten the knobs on both ends.
3. Slip the end caps onto the ends of the speaker, from
the rear toward the front.
Rotating the Logo Badge
The logo badge is permanently attached to the grille, but can be rotated to accommodate both vertical and horizon-
tal speaker orientations. To rotate the badge, simply pull it straight away from the grille and turn it.
4. Check to make sure there are no stray strands of wire
outside the terminals. If there are, remove the wire,
twist the strands together, and reconnect the wire to
the terminal.
INSTALLATION
5
Advertisement
Table of Contents
