Table of Contents
Advertisement
Insert tube ring sections into socket at top of leg and align screw holes. Secure using #10-24x5/8"self tapping screws.
Shown Fig. A.
NOTE: Assembly will be
easier if you turn the unit up-
side down for steps 1 & 2.
Leg
Tube Ring
Section
Figure A
Attach Lattice panels to legs using #10-24x3/8" screws as Shown Fig. A. Repeat for each Lattice panel/Leg assembly.
Completed Assembly shown upright in Fig. B.
Leg
Figure A
Page 4
PRODUCT ASSEMBLY
Tube Ring
Section
Screws
Figure B - Completed Assembly
(shown upside down)
Lattice Panel
NOTE: Unit should remain
upside down during this step.
Turn unit over once this step
is complete.
Figure B - Completed Assembly
Shown upright
Advertisement
Table of Contents
