Needle Clamp Screw - Brother 885-V12 Operational Manual

GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
d Loosen the needle clamp screw and remove
the needle.
Hold the needle with your left hand, and then
turn the screwdriver counterclockwise with
your right hand.
a Needle clamp screw
b Screwdriver
• Do not apply extreme force when loosening
or tightening the needle clamp screw,
otherwise damage to the machine may
result.
e With the flat side of the needle toward the
rear of the machine, insert the needle until it
touches the needle stopper.
a Needle stopper
32
b
a
a
f While holding the needle with your left hand,
tighten the needle clamp screw.
Turn the screwdriver clockwise.
Install the twin needle in the same way.
CAUTION
● Be sure to insert the needle until it touches
the needle stopper and securely tighten the
needle clamp screw with the screwdriver,
otherwise the needle may break or damage
may result.