Important Safety Instructions; Power Off - Kenwood KSC-SW11 Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS

Caution: Read this page carefully to ensure safe operation.
• Before mounting or wiring etc., be sure to remove the
wire from the battery minus terminal.
(Not doing so can cause shorts or fires.)
• When extending the ignition, battery, or ground wires,
make sure to use automotive-grade wires or other wires
2
with a 0.75mm (AWG18) or more to prevent wire deterio-
ration and damage to the wore coating.
• To prevent a short circuit, never put or leave any metallic
objects (such as coins or metal tools) inside the speaker.
• In the event the unit generates smoke or abnormal smell,
immediately switch the power OFF. After this, please
contact your dealer or nearest service station as soon as
possible.

POWER OFF!

• Connect the speaker to DC 12V, negative ground.
• Do not attempt to open or modify the unit, for this could
cause fire hazard or malfunction.
• After taking the unit out of the polyethylene bag, be sure
to dispose of the polyethylene bag out of the reach of
children. Otherwise, they may play with the bag, which
could cause hazard of suffocation.
• Installation and wiring of the product requires expert skill
and experience. To ensure safety, be sure to have your
dealer or specialist perform the installation and wiring.
• Do not install the speaker in a spot exposed to direct sun-
light or excessive heat or humidity.
• Do not install the speakers in locations which may be
subject to water or moisture.
• Do not install the speakers in unstable locations or loca-
tions subject to dust.
• If the fuse blows, after checking to see if the wiring cord
has shorted, be sure to replace with the stipulated size
(amperage) fuse as displayed on the fuse box.
(Using fuses other than the stipulated size can cause
fires.)
Check the display!
To replace the fuse, refer to the vehicle instruction manu-
al.
• To prevent a short circuit when replacing a fuse, discon-
nect the wiring harness at first.
• Do not use gasoline, naphtha, or any type of solvent to
clean the speaker. Clean by wiping with a soft, dry cloth.
• Connect the speaker wires to appropriate speaker con-
nectors separately. Sharing the negative wire of the
speaker or grounding speaker wires to the metal body of
the car can cause this unit to fail.
• When making a hole under a seat, inside the trunk, or
somewhere else in the vehicle, check that there is noth-
ing hazardous on the opposite side such as a gasoline
tank, brake pipe; or wiring harness, and be careful not to
cause scratches or other damage.
• For ground wire mounting, do not fasten the wire to
an airbag, steering or brake line system or other critical
safety unit bolts or nut.
(Can cause accidents.)
• When mounting, be sure to mount in a place that will not
interfere with driving or be dangerous to passengers dur-
ing sudden braking etc.
(Cause of injury or accidents.)
2
English
WARNING
CAUTION
• After installing the unit, check to make sure that electrical
equipment such as the brake lamps, turn signal lamps
and windshield wipers operate normally.
• The driver should always stop the vehicle in a safe place
before performing the following action.
– Remote control operation
• Do not use the product for purposes other than on-board
mounting.
Declaration of Conformity with regard to
the EMC Directive 2004/108/EC
Manufacturer:
JVCKENWOOD Corporation
3-12, Moriyacho, Kanagawa-ku, Yokohamashi, Kanagawa,
221-0022, Japan
EU Representative's:
Kenwood Electronics Europe BV
Amsterdamseweg 37, 1422 AC UITHOORN,
The Netherlands
Information on Disposal of Old Electrical and Elec-
tronic Equipment (applicable for countries that
have adopted separate waste collection systems)
Products with the symbol (crossed-out
wheeled bin) cannot be disposed as house-
hold waste. Old electrical and electronic
equipment should be recycled at a facility
capable of handling these items and their
waste by products.
Contact your local authority for details in locating a
recycle facility nearest to you. Proper recycling and
waste disposal will help conserve resources whilst
preventing detrimental effects on our health and the
environment.
For Turkey
Bu ürün 28300 sayılı Resmi Gazete'de yayımlanan Atik
Elektrikli ve Elektronik Eşyalarin Kontrolü Yönetmeliğe
uygun olarak üretilmiştir.
Eski Elektrik ve Elektronik Ekipmanların İmha Edil-
mesi Hakkında Bilgi (ayrı atık toplama sistemlerini
kullanan ülkeleri için uygulanabilir)
Sembollü (üzerinde çarpı işareti olan çöp
kutusu) ürünler ev atıkları olarak atılamaz.
Eski elektrik ve elektronik ekipmanlar, bu
ürünleri ve ürün atıklarını geri dönüştürebile-
cek bir tesiste değerlendirilmelidir.
Yaşadığınız bölgeye en yakın geri dönüşüm tesisinin
yerini öğrenmek için yerel makamlara müracaat edin.
Uygun geri dönüşüm ve atık imha yöntemi sağlığımız
ve çevremiz üzerindeki zararlı etkileri önlerken kaynak-
ların korunmasına da yardımcı olacaktır.