Table of Contents
Advertisement
Loading Discs
The next step is to load your PF-Pro Disc Printer with output discs. The system will accept CD or
DVD 120 mm (12 cm) inkjet printable discs. If the disc does not have an inkjet printable surface, the
ink will not adhere to the surface of the disc. The PF-Pro Disc Printer will only accept 12 cm discs.
Business card or 8 cm discs are not supported by this system.
Load the first 5 or 6 discs flat, as seen in figure 1.
Load the rest of the discs at an angle, against the wide input rod, as seen in figure 2.
The PF-Pro Disc Printer will hold a maximum of 100 discs. DO NOT load more than 100 discs in the
system, as this may cause the discs to feed incorrectly.
Front Panel Indicators and Buttons
1. Power
1. Power Button and LED – The Power button turns the PF-Pro Disc Printer on and off. It may
take a few seconds for the PF-Pro Disc Printer to turn on after you press the Power button.
The green LED on the Power button flashes when the printer is processing.
NOTE: The AC power switch located on the back of the PF-Pro Disc Printer must
be turned on first in order to supply power to the Front Panel.
2. Network Button - This button is unused.
3. Cancel Button – Pressing the Cancel button cancels the current print job.
4. Media Feed Button – Pressing this button will clear any media feed issues. This button has
an LED that will flash amber when a media feed issue is occurring. It will also show a steady
amber if either the ink or the upper doors are opened.
5. Print Head LEDs – These LEDs will be on if there is an issue with either of the print heads.
• Assembly and Installation
8
Figure 1
2. Network (unused)
3. Cancel
4. Media Feed
Figure 2
5. Print head
LEDs
Advertisement
Table of Contents
