Summary of Contents for Power Wheels Kawaaki Super Shock 73600
Page 1
® are trademarks used under license by Kawasaki Motors Corp., U.S.A. However, this product is neither manufactured nor distributed by Kawasaki Motors Corp., U.S.A. Consumer inquiries should be directed to: Power Wheels by Fisher-Price ® Owner's Manual with Assembly Instructions...
• Use this vehicle ONLY outdoors. Most interior floor- service center nearest you, or call ing can be damaged by riding this vehicle indoors. 1-800-348-0751. Fisher-Price ® will not be responsible for damage to • Please complete and return the enclosed Registration the floor if the vehicle is used indoors.
Warnings and Cautions ELECTRICAL HAZARD WARNING • Battery can fall out and injure a child if vehicle tips over. Always use battery clamp. • PREVENT FIRE - Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also ruin the electrical system.
Parts • If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store. • Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded.
Page 5
Parts .437" Drive Axle .437" Front/Rear Axle - 2 Large Wheel - 2 .437" Lower Shock Rod .437" Upper Shock Rod Front Fender .354" Fork Axle Right Grip with Large Hole Steering Stop Driver - 2 Inside Half Outside Half Axle Retainer - 2 Sets Left Grip with Small Hole...
Parts Hex Bushing - 6 12 Volt Charger 12 Volt Battery Not Shown: Label Sheet *Note: For your convenience, we have included four extra cap nuts (three .437 and one .354). .437" #8 x " Screw – 14 .437 Cap Nut – 7* .354"...
Battery Charging About Thermal Fuses ELECTRICAL HAZARD Your Power Wheels 12 volt battery with 12 volt connector is equipped with a built-in thermal fuse. The thermal fuse WARNING is a self-resetting safety device which automatically “trips” and shuts down operation of the vehicle if the vehicle is overloaded or the driving conditions too severe.
Page 9
Battery Charging Plastic Retainer Battery Battery Charger Connector • Plug the charger connector into the battery • Plug the charger into a standard 120 volt wall outlet Note: If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”. Plastic Retainer •...
Assembly WARNING Children can be harmed by small parts, sharp edges and sharp points in the vehicle’s unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery, or help in assembly of the vehicle. Lift Seat Remove Front/Rear Axle...
Page 11
Assembly Rear of Vehicle Frame .437 Cap Nut Lower Shock Rod .437" Narrow End of Monoshock .437 Cap Nut Hole • Place a .437 cap nut on a flat surface, inside up, as shown. Hint: You may want to place a scrap block of wood underneath the cap nut to protect the assembly surface.
Assembly End of Lower Shock Rod Lower .437 Cap Nut Hole Inset Lower Shock Rod .437 Cap Nut Right Side View • Lower the moveable .437" top piece of the Left Side View vehicle frame. • Slide the lower shock •...
Page 13
Assembly Upper Shock Rod End of Upper Shock Rod Upper Hole .437 Cap Nut Inset .437 Cap Nut .437" Right Side View Left Side View • Slide the upper shock • Fit a .437 cap nut on the other end of the upper shock rod. rod through the upper •...
Assembly Driver (Ribbed Side Up) Hex Bushing Rear Wheel Rear Wheel (Indented Side Up) Hex Bushing Keyed Side • Fit a hex bushing, keyed side down, into the center hole • Position a rear wheel with indented side up. in of each rear wheel. •...
Page 15
Assembly Fender Retainer (Outside) Retainer (Inside) Drive Axle Right Side View • Fit a retainer to the inside and outside of the back end of Right Side View the vehicle frame, as shown. • Insert a #8 x " screw through the outside retainer and •...
Assembly .437 Cap Nut Large Wheel (with Hex Bushings) .437" Retainer Retainer .437 Cap Nut • Fit one of the large wheels (with hex bushings) between End of Axle the retainers on the back end of the vehicle frame. Left Side View •...
Assembly Battery Compartment Door .354 Cap Nut Fork Axle .354" .354 Cap Nut Battery Compartment • Place a .354 cap nut on a flat surface, inside up, as shown. Hint: You may want to place a scrap block of wood underneath the cap nut to protect the assembly surface.
Assembly .354 Cap Nut Handlebar Assembly Neck End of Fork Axle .354 Cap Nut Hold the .354" Steering Stop in Place • While holding the steering stop in place, slide the handlebar assembly onto the neck of the vehicle frame. •...
Page 19
Assembly Number Plate Front Fender Left Shock • Insert two #8 x " screws through the left shock to • Insert a #8 x " screw through the number plate and secure it to the left fork. into the front fender. •...
Assembly .437 Cap Nut Right Shock Front/Rear Axle .437 Cap Nut .437" • Insert a #8 x " screw through the right shock to secure it to the right fork. • Slide the remaining front/rear axle through the left shock, •...
Page 21
Assembly Large Hole Motor Harness Plug Right Handlebar Rectangular Hole Right Hand Grip • Fit the right grip on the end of the right handlebar. Hint: If it is difficult to slide the grip onto the handlebar, • Fit the motor harness plug underneath the gas tank and moisten the inside of the grip with water.
Label Decoration Proper label application will help to keep the labels looking their best! When applying labels, keep the following guidelines in mind: • Wash your hands before applying the labels. • Before applying the labels, wipe the surface of the vehicle with a clean, dry cloth to remove any dust or oils. •...
Battery Installation IMPORTANT! Use only Power Wheels ® 12 volt battery. Use of any other battery will damage your vehicle. Make sure that you charge the battery for at least 18 hours using the enclosed Power Wheels ® 12 volt charger before operating your vehicle for the first time.
Battery Care Battery Care and Disposal and Disposal Care Disposal If a battery leak develops, avoid contact with the leaking • Your Power Wheels ® battery is sealed lead-acid battery. acid and place the damaged battery in a plastic bag. See It must be recycled or disposed of in an environmentally information below for proper disposal.
Rules for Safe Driving RIDING HAZARD 7. Do not allow your child to drive on sloped or inclined WARNING surfaces. Restrict your child’s driving to generally level ground ONLY! 8. Do not allow your child to drive down or across a Prevent Injuries and Deaths steep slope.
How to Operate Your Vehicle IMPORTANT! Use this vehicle ONLY outdoors. Most interior flooring can be damaged by riding this vehicle indoors. Fisher-Price ® will not be responsible for damage to the floor if the vehicle is used indoors. Beginner Use - Low Speed...
How to Operate Your Vehicle Bumper-to-Bumper* Limited Warranty Advanced Use - High Speed IMPORTANT! Your child should not drive the vehicle in *One year limited warranty from the date of HIGH SPEED from a stopped position. Always start in purchase on the Power Wheels ®...
Problems and Solutions Guide IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still experience a problem, please contact Power Wheels Consumer Relations, ® toll-free at 1-800-348-0751 between 8 AM and 6 PM (EST) Monday through Friday. Or, contact your local Power Wheels authorized service center.
Page 30
Problems and Solutions Guide Problem Possible Cause Solution Vehicle was running but Loose wire or loose connectors Check all wires and connectors. Make sure the motor suddenly stopped harness connector is tightly plugged into the battery, and that there are no loose wires around the motors. Tripped thermal fuse Each Power Wheels ®...
Page 31
Problems and Solutions Guide Problem Possible Cause Solution Problem Possible Cause Solution Vehicle runs sluggishly (cont.) Battery needs charging Be sure to charge the battery after each use. Battery is old and will not accept Even with proper care, a rechargeable battery does not accept full charge last forever.
Authorized Service Centers We are continually expanding our independently owned and operated Authorized Service Center Network. Please check this listing for the Authorized Service Center nearest you. If there is not one in your area, please call Power Wheels ® Consumer Relations at 1-800-348-0751.
Page 33
Authorized Service Centers NASHVILLE - Kesel Hardware, 173 West St. Louis, LAKE CHARLES - Capitol Schwinn Cyclery, PRUDENVILLE - Ford’s Do-It Center, 841 W. Houghton 62263, (618) 327-8957 722 E. Prien Lake Road, 70605, (337) 474-9090 Lake Drive, 48651, (517) 366-7622 NILES - Household Appliance Sales &...
Page 34
Authorized Service Centers NEW MEXICO OHIO MOSCOW - Vac-Way Appliance & Service, RR #6 Box 6237, 18444, (570) 842-4668 ALBUQUERQUE - Appliance Service Center, AKRON - Advanced Appliance Service Company, 3219 Candelaria, NE, 87107, (505) 265-7774 73 W. Exchange Street, 44308, (330) 762-8968 ORANGEVILLE - Hess Do-It Center &...
Page 35
Authorized Service Centers TEXAS UTAH WEST VIRGINIA AMARILLO - Reid’s Appliance Service, Inc., OREM - The Mending Shed, 1735 South State Street, BECKLEY - Jerry’s Detectors, Vacuum & Appl. Svc., 906 Georgia, 79102, (806) 373-8812 84058, (801) 225-8012, (800) 339-9297 411 Second Street.
Page 36
Authorized Service Center list in this manual. Fisher-Price, Power Wheels, Power Wheels by Fisher-Price, Power Lock and Super Shock Dirt Bike are U.S. trademarks of Mattel, Inc. Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052 U.S.A.