Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Swann HD PenCam
Summary of Contents for Swann HD PenCam
- Page 1 MPEN720310812E...
-
Page 2: Before You Begin
Before You Begin IMPORTANT NOTE: Prohibition against eavesdropping All jurisdictions have specific laws and regulations relating to the use of cameras. Before using any camera for any purpose, it is the buyer’s responsibility to be aware of all applicable laws and regulations that prohibit or limit the use of cameras and to comply with the applicable laws and regulations. - Page 3 Operating the Pencam Turning the PenCam On • Press the power/record button (on top off the pen) and hold until the both the orange and blue lights turn on then release it. When the camera is ready to use the orange standby light will stay on and the blue light will turn off. • The orange light will blink when it is on standby in picture mode or stay lit when it is on standby in video mode.
-
Page 4: Picture Mode
Picture Mode Taking pictures from power off Make sure the PenCam is off and that the selection switch inside the PenCam is set to 1 (picture mode). Press and hold the power/record button. A blue and orange light will Standby mode = Orange illuminate simultaneously for about light two seconds. -
Page 5: Mounting The Camera
Mounting the Camera IMPORTANT NOTE: When stopping a recording push the button only 1 time. The PenCam will write the video to memory. Depending on the length and complexity of the video there may be several seconds delay. Do not push the button again during this time or data loss may occur. -
Page 6: Troubleshooting
Downloading and Viewing Video When the PenCam is connected to a computer running Windows XP, Windows Vista, Windows 7 or Mac OS X, the operating system will automatically recognize the device and install the correct drivers. Navigate to the Removable Disk in My Computer to view, copy or delete files just like a portable hard drive or flash drive. -
Page 7: Specifications
Resetting the PenCam If the PenCam is not responding correctly you may need to reset the PenCam. To reset the PenCam use a toothpick or non-metal pointed object to push the reset button which is located about 1 inch below the Orange/Blue light. Metal objects may damage the PenCam and should be avoided. -
Page 8: Helpdesk / Technical Support Details
Any unit which proves defective during the stated period will be repaired without charge for parts or labor or replaced at the sole discretion of Swann. The end user is responsible for all freight charges incurred to send the product to Swann’s repair centers. The end user is responsible for all shipping costs incurred when shipping from and to any country other than the country of origin.