Power On Router - D-Link DSL-504 User Manual

The DSL-504 can provide a secure gateway to the Internet for small and medium sized Ethernet LANs.
Sample Ethernet LAN with the DSL-504 Gateway

Power On Router

To power on the device:
1. Insert the AC Power Adapter cord into the power receptacle located on the rear panel (see Figure 2 - 2. Rear
Panel) of the Router and plug the adapter into a nearby power source.
2. You should see the Power LED indicator light up and remain lit. The Status LED should light solid green
and begin to blink after a few seconds.
3. If you have the Router connected to your network you can look at the Ethernet Link/Act LED indicators to
make sure they have valid connections. The Router will attempt to establish the ADSL connection, if the
ADSL line is connected and the connection is properly configured (see Chapter 4) this should light up after
several seconds.
DSL-504 ADSL Router User's Guide
6