Electronic Timer - Hotpoint EW36 Instructions For Installation And Use Manual

Electronic timer

This function displays the time and works as a timer which counts down to zero.
Note: All functions will be implemented approximately 7 seconds after they have been set.
Resetting After the appliance has been connected to the power supply, or after a power cut, the clock
the clock display will begin to blink, showing the figure: 0:00
•
buttons to quicken the count upwards.
Any necessary modifications can be made by repeating the above process.
Timer
This function may be accessed by pressing the
feature
the symbol
seconds, until it reaches 99 minutes and 50 seconds. After this point, each press of the
button represents an increase of one minute, up to a maximum of 10 hours.
Pressing the
After the time period has been set, the timer will begin to count down. When the timer
reaches zero, the buzzer will sound (this may be stopped by pressin
The time may be displayed by pressing the
timer function has been set. After approximately 7 seconds, the display will automatically
revert to the timer.
Cancelling a
Press the
time that has
already been set
Adjusting the
After selecting and confirming the clock settings, use the
buzzer volume
buzzer.
G
Press button and then buttons
n
. Every time the
-
button reduces the time.
-
button until the display shows 0:00.
- +
and to set the exact time. Press and hold the
n
button, after which the display will show
+
button is pressed it corresponds to a time increase of 10
G
button, and the
-
g any button).
n
symbol indicates that the
button to adjust the volume of the alarm
25