Operation; Turntable Operation - Crosley CR6249A Instruction Manual

Turntable Operation

1 Set the SPEED CONTROL SWITCH (3) to
the correct speed(33 1/3 , 45 or 78 rpm)
2 Place the record on the TURNTABLE(10)
3 Use the CUE LEVER(2) to raise the tone
arm off its rest. Move the tone arm over the
record and use the CUE LEVER(2) to
lower it to the point from which you want
the record to start.
4 Turn the VOLUME KNOB(8) to adjust the
volume to the desired level.
5 Turn the TONE CONTROL((7)to adjust the
tone level.
6 At the end of the record, the tone arm will
return to its rest.
USB Operation
Using the included software and cable, the
USB connection allows you record your
records onto your computer, Follow these
instructions to use the USB．
1 Insert the enclosed software CD into your
computer.
2 Follow the instructions on the computer
screen to install the software. If the CD
does not load automatically, browse the
CD run the executable file called "CR-
USB.exe."
3 Connect the square end of the USB cable
to the USB JACK (16) on the right side of
the turntable.
4 Connect the other end to a USB port on
your computer.
5 On your computer, open the Record
Recording Software.
6 For instruction on operating the Record
Recording Software, browse the software
CD and open the Manuals folder.

Operation

Accessory: ADAPTER FOR 45RPM
This adapter allows you to play 45 RPM records.
1 Place the 45 RPM ADAPTER(11) over the
spindle.
2 Gently place your 45 RPM record onto the
turntable.
3 Follow the steps under turntable operation to
play your record.