Table of Contents
Advertisement
Malfunction
The cycle indicator for the se
lected dishwashing cycle is
flashing:
Å 10
fault code
is displayed
in the multi display:
(Problems with water inlet)
The cycle indicator for the se
lected dishwashing cycle is
flashing,
Å 20
fault code
is displayed
in the multi display.
(Problems with water drain
age)
Å 30
Fault code
is displayed
in the multi display.
The cycle is not starting.
Possible cause
Water tap is blocked with
limescale or faulty.
The tap is turned off.
The filter (where present) in the
threaded hose fitting on the
tap is blocked.
Filters in the base of the dish
washer compartment are
blocked.
Water inlet hose
has not been correctly posi
tioned.
The sink outlet is blocked.
Water drain hose
has not been correctly posi
tioned.
The anti flood system has been
triggered.
The mains plug is not
plugged in.
A fuse in the house's wiring
system is defective.
For dishwasher models with a
delay start timer:
A start time has been selected.
What to do if...
Remedy
Check the water tap and have it
repaired if necessary.
Turn the tap on.
Clean the filter in the threaded
hose fitting.
Cancel the dishwashing cycle
(see chapter: Starting a dish
washing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing cy
cle again.
Check the position of the hose.
Clean out sink outlet.
Check the position of the hose.
First shut off the water tap,
then switch off the appliance
and contact the Customer Care
Department.
Plug in mains plug.
Replace fuse.
If the dishes are to be washed
immediately, cancel the delay
start.
31
Advertisement
Table of Contents
