Toshiba A5 User Manual page 153

TV output signal
Problem
Display on TV is poor
No display
If you turn the computer off in Standby Mode while the display is on a TV,
the computer will select either the internal LCD or an external computer CRT
as the display device the next time it is switched on.
Standby/Hibernation
Problem
The system will not
enter Standby/
Hibernation
Real Time Clock
Problem
The RTC battery
charge has become
exhausted, you should
set the date and time in
within the BIOS setup
screen through the
following steps:
RTC battery is low or
CMOS checksum is
inconsistent. Press
[F2] key to set Date/
Time.
TOSHIBA A5
Procedure
Make sure the TV type is correct for your area:
NTSC (US) or PAL (Europe).
Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display.
Refer to Chapter 5,
If problems persist, contact your dealer.
Procedure
®
Is Windows Media Player open? The system
might not enter Standby/Hibernation, if
®
Windows Media Player is either playing a
selection or finished playing a selection. Close
®
Windows Media Player before you select
Standby/Hibernation.
If problems persist, contact your dealer.
Procedure
The following message is displayed on the LCD:
1. Press [F1] key. BIOS setup will boot up.
2. Press [F2] to set the date in [System Date].
3. Press [F2] to set the time in [System Time].
Troubleshooting
The Keyboard.
9-14