Installation Of The Cpu And Cpu Cooler; Installation Of The Cpu - XFX GeForce 8300 (MI-A78U-8309) User Manual

XFX Motherboard Series

2.3 Installation of the CPU and CPU Cooler

Before installing the CPU, please comply with the following conditions:
1. Please make sure that the mainboard supports the CPU.
2. Please take note of the one indented corner of the CPU. If you install the CPU in the wrong
direction, the CPU will not insert properly. If this occurs, please change the insert direction
of the CPU.
3. Please add an even layer of heat sink paste between the CPU and CPU cooler.
4. Please make sure the CPU cooler is installed on the CPU prior to system use, otherwise
overheating and permanent damage of the CPU may occur.
5. Please set the CPU host frequency in accordance with the processor specifi cations. It is not
recommended that the system bus frequency be set beyond hardware specifi cations since
it does not meet the required standards for the peripherals. If you wish to set the frequen-
cy beyond the proper specifi cations, please do so according to your hardware
specifi cations including the CPU, graphics card, memory, hard drive, etc.

2.3.1 Installation of the CPU

1. Unlock the socket by pressing the
lever sideways, then lift it up to a 90
Figure 1
4. When the CPU is in place, push down
the socket lever to secure the CPU.
The lever clicks on the side tab to
indicate that it is locked.
2. Position the CPU above the socket such
o
.
that the CPU corner with the gold
triangle matches the socket corner with
a small triangle.
3. Carefully insert the CPU into the socket
until it fi ts place.
Figure 3
- 8 -
User Guide
Figure 2