Redundant Array Of Independent Drives (Raid); Controller; Hp 1Tb 10K Rpm Sata 6.0Gb/S 3.5" Hard Disk Drive - HP EliteDesk 800 G1 Series Quickspecs

QuickSpecs
Technical Specifications – Hard Disk and Solid State Storage

Redundant Array of Independent Drives (RAID)

Flexible implementation:
DriveLock is supported while in RAID mode. Users can manage the DriveLock password from within F10 Setup. Locked drives will
be displayed as such in the RAID option ROM interface.
Hard drive information can be viewed within F10 Setup while in RAID mode. Previously, the hard drives will not appear in Drive
Configuration when switching to RAID mode.
DPS Self Test can be executed on physical hard drives while in RAID mode.
The RAID Setup Utility (accessed through CTRL-I) can be protected by the F10 Setup password.
NOTE:
RAID 1 is the only RAID configuration offered via factory configurations. The pre-configured systems:
Are only available on the SFF and TWR form factors. The USDT does not support RAID as it does not allow for more than one hard
disk drive
Are complete RAID systems and have both drives installed. If the TWR is configured with three hard disk drives, the third drive is
would be un-partitioned and not part of the RAID array
Have the necessary Option ROM configuration.
Are pre-loaded and pre-installed with all required Intel software.
Include a preinstalled operating system that is mirrored mode out of the box.

Controller

Hard Drive Controller
SATA Interfaces
Host SATA Controller

HP 1TB 10K rpm SATA 6.0Gb/s 3.5" Hard Disk Drive

Capacity
Rotational Speed
Interface
Synchronous Transfer Rate
(Maximum)
Buffer Size
Cache
Seek Time (typical reads,
includes controller overhead,
including settling)
Height (nominal)
USDT
These systems provide up to four serial ATA (SATA) interfaces that support transfer rates up to
6.0 Gb/s (for ports 0 and 1, 3 Gb/s on all others) and RAID data protection functionality. These
systems can also support an external SATA (eSATA) device through an optional bracket/cable
assembly (does not apply to USDT).
2 ea. SATA 3.0
Advanced Host Controller Interface (AHCI) Revision 1.2. The specification includes a description of
the hardware/software interface between system software and the host controller hardware.
1 TB
10,000 rpm
Serial ATA (6.0 Gb/s)
Up to 600 MB/s
64 MB
Adaptive
Single Track:
Average:
Full-Stroke:
0.6 in/1.53 mm
DA - 14653 North America — Version 5 — July 18, 2013
HP EliteDesk 800 G1 Series Business Desktop
SFF
2 ea. SATA 3.0
1 ea. SATA 2.0
1.2 ms
3.6 ms
9.0 ms
TWR
2 ea. SATA 3.0
2 ea. SATA 2.0
Page 27