KitchenAid 30" Installation Instructions And Use & Care Manual page 14

6. Install the blower motor box assembly to the opposite side
(rear) of the vent box with the vent located in the bottom
venting position. Place the bottom tab of the blower box into
the bottom mounting channel.
A. Blower box
B. Bottom mounting channel
7. Plug in the wire connector to the blower motor.
A
B
A. Blower motor
B. Wire connector
8. Tilt blower box top tab so it is flush with the vent box panel
and position it under the top mounting bracket. Slide bracket
into the "Z" slots and tighten the 2 hex/slotted head screws
to secure.
14
B
A
9. Reinstall panel to front side of vent box panel. Place bottom
tab of the panel into the bottom mounting channel.
A. Blower mounting channel
B. Panel
10. Tilt panel top tab so it is flush with the vent box panel and
position it under the tip mounting bracket. Slide bracket into
the "Z" slots and tighten the 2 hex/slotted head screws to
secure.
11. See "Complete Installation - Interior Mounted Motor" section.
B
A