Behringer PRO MIXER VMX100 User Manual page 9

The GND connection allows grounding of a turntable.
22
Use the AMP output to connect the VMX100 to an amplifier. The level is controlled by the MAIN knob in
23
the MIC/MAIN section.
+
The TAPE output enables you to record your performance by connecting a tape deck, DAT recorder etc.
24
Unlike the AMP output, the TAPE level is fixed, so that you have to adjust the input level on the recorder.
The POWER ON switch turns on the PRO MIXER.
25
FUSE HOLDER/VOLTAGE SELECTOR. Before you connect the equipment to an AC outlet, please be
26
sure that the voltage displayed corresponds with your local AC voltage. If you should need to replace the
fuse, be sure to replace it with one of the same type and value. Some units allow you to switch between
230 V and 115 V by rotating the fuse holder.
+
This is the socket for the power cable. The impulse behavior of any given amplifier circuit depends
27
largely upon the power supply’s inherent reserves. All mixers contain numerous operational amplifiers
(op-amps) for processing line-level signals. Due to the restricted performance of their power supplies,
many mixers show “stress symptoms” when used under extreme conditions, resulting in inferior audio
quality. Thanks to its generously proportioned power supply, this will never happen to your VMX100: The
sound will always be clear, transparent and powerful.
SERIAL NUMBER. Please take the time to fill out and return the warranty card within 14 days after the
28
date of purchase. This will entitle you to all the benefits of our extended warranty. Alternatively, you can
register online at www.behringer.com.
PRO MIXER VMX100
3. REAR PANEL
9