Air Flow Monitor; Pump Protection - Baxi COMBI 105 HE User Operating Instructions Manual

Pump/Low
Sensor Fault
Pressure Neon
Neons
Air Flow
Monitor Neon
o o o o o
30 40 50 60 70 80
Fig. 12
Reset
Fig. 13
Reset
Fig. 14
8
© Baxi Heating UK Ltd 2007
o
3.0 Operating the Boiler
3.5

Air Flow Monitor

1. The boiler is fitted with an air pressure sensing device.
This monitors the flue system.
2. If the neon illuminates (
or flue terminal is blocked or obstructed in some way,
or that there is an internal fault. If there is no external
blockage of the flue terminal that can be easily removed
contact your Installer or Service Engineer (Fig. 12).
3.6 Pump Fault or Low Pressure
1. The neon ( ) will illuminate if the circulating pump
is faulty or the system pressure drops below the
minimum requirement (Fig. 12).
2. Check the pressure gauge as described in Section 3.9.
If the pressure is in the normal range, a pump fault is
indicated. Contact your Installer or Service Engineer to
determine the nature of the fault.
3.7 Sensor Fault
1. When the ( ) or ( ) neon is illuminated a fault
on the hot water or central heating temperature sensor
is indicated (Fig. 12). Contact your Installer or Service
Engineer.
3.8

Pump Protection

1. With the selector switch in either Position (i) or
Position (ii) (Figs. 13 & 14) the pump will automatically
operate for 1 minute in every 24 hours to prevent
sticking.
) it indicates that the flue