Kenmore 795.7205 Series Use & Care Manual page 13

REFRIGERATOR INSTALLATION
REFRIGERATOR INSTALLATION
Reinstalling the Refrigerator Door
Reinstalling the Refrigerator Door
Left Door
Left Door
1. Lower the door onto middle hinge pin (10).
1. Lower the door onto middle hinge pin (10).
2. Fit top hinge (7) over hinge lever latch (8) and into
2. Fit top hinge (7) over hinge lever latch (8) and into
place. Rotate lever (6) clockwise to secure hinge.
place. Rotate lever (6) clockwise to secure hinge.
3. Install the grounding screw (5) and connect the two
3. Install the grounding screw (5) and connect the two wire
wire harnesses (4).
harnesses (4).
4. Push the water tube (3) located at the top of the left
4. Push the water tube (3) located at the top of the left
door into the hole beside the left hinge on the top of
door into the hole beside the left hinge on the top of
the cabinet until it exits through the back.
the cabinet until it exits through the back.
5. Insert the water supply tube (3) into the connector until
5. Insert the water supply tube (3) into the connector until
you see only one scale mark. Fully insert the tube over
you see only one scale mark. Fully insert the tube over
⅝ in. (15 mm).
⅝ in. (15 mm).
6. Hook tabs on left side of hinge cover (1) under the
6. Hook tabs on left side of hinge cover (1) under the edge
edge of the top hinge (7) and position the cover in
of the top hinge (7) and position the cover in place.
place. Insert and tighten the cover screw (1).
Insert and tighten the cover screw (1).
(2)
(2)
(3)
(3)
(5)
(5)
(6)
(6)
(7)
(8)
(7)
(8)
CAUTION
CAUTION
(1)
(1)
(4)
(4)
(10)
Collet
Collet
Tube
Tube
Scale Mark
Scale Mark
Clip
Clip
Right Door
Right Door
1. Lower the door onto middle hinge pin (9).
1. Lower the door onto middle hinge pin (9).
2. Fit top hinge (4) over hinge lever latch (5) and into
2. Fit top hinge (4) over hinge lever latch (5) and into
place. Rotate lever (3) counterclockwise to secure
place. Rotate lever (3) counterclockwise to secure
hinge.
hinge.
3. Hook the tabs on right side of hinge cover (2) under
3. Hook the tabs on right side of hinge cover (2) under
the edge of the top hinge (4) and position the cover in
the edge of the top hinge (4) and position the cover in
place. Insert and tighten the cover screw (1).
place. Insert and tighten the cover screw (1).
After inserting, pull the tube to
After inserting, pull the tube to
make sure that it is secure and
make sure that it is secure and
reinsert the clip.
reinsert the clip.
14
14
(1)
(1)
(3)
(4)
(3)
(4) (5)
(5)
(9)
(2)
(2)